Abstract:Immer häufiger werden Spannbetonbrücken in Deutschland zurückgebaut. Problematisch ist dabei in der Regel die ungenügende Kenntnis über die Eigenschaften der verbauten Bestandsmaterialien. Insbesondere der Zustand der Spannglieder und des Verpressmörtels lässt sich nur schwer feststellen. Im Zuge des Rückbaus kann eine Durchtrennung der Spannglieder abseits der Koppelfugen aus bauablaufsbedingten Gründen von Vorteil sein. Voraussetzung für die Sicherstellung der Tragsicherheit des Rückbauabschnitts ist eine erfolgreiche Verbundverankerung der Spannglieder mit dem umgebenden Verpressmörtel, dem Hüllrohr und dem Beton. Neben einem guten Zustand der Spannglieder und des Verpressmörtels ist eine ausreichende Kenntnis dieses Verbundverhaltens daher essentiell. Angaben zu den Verbundeigenschaften des bei der Talbrücke Unterrieden verbauten Spannstahls ließen sich in der Literatur jedoch kaum finden. Daher wurden während des Rückbaus der Talbrücke Unterrieden Untersuchungen zur Erkundung des Zustands der Spannglieder durchgeführt. Dazu gehörten Rückdehnungsmessungen zur Ermittlung der vorhandenen Vorspannung und Zugversuche an Spannstäben, die im Anschluss an die Rückdehnungsmessungen aus dem Bauwerk entnommen wurden. Weiterhin wurden Verbundprobekörper aus der Brücke entnommen und im Labor getestet, um Rückschlüsse auf das Verankerungsverhalten der Spannglieder ziehen zu können. Anhand dieser Untersuchungen sollen die in der Rückbauplanung getroffenen Annahmen verifiziert werden. Translation abstract Re‐anchoring during severing of historical tendons Prestressed concrete bridges are increasingly being dismantled in Germany. The problem here is usually the insufficient knowledge of the properties of the materials used. In particular, it is difficult to determine the condition of the tendons and the grouting. In the course of dismantling, the cutting through of tendons away from the coupling joints can be advantageous for construction‐related reasons. A prerequisite for ensuring the structural safety of the dismantling section is successful bond anchoring of the tendons with the surrounding grout, the duct, and the concrete. In addition to a good condition of the tendons and the grouting, sufficient knowledge of this bond behavior is therefore essential. However, information on the bond properties of the prestressing steel used in the Unterrieden viaduct could hardly be found in the literature. For this reason, investigations were carried out during the dismantling of the Unterrieden viaduct to determine the condition of the tendons. This included strain recovery measurements to determine the existing prestressing and tensile tests on prestressing bars, which were removed from the structure subsequent to the strain recovery measurements. Furthermore, bond specimens were taken from the bridge and tested in the laboratory in order to draw conclusions about the anchorage behavior of the tendons. These investigations are intended to verify the assumptions made in the dismantling planning.

Damage tolerance and collapse mechanism of failed prestressing steel strands in a 50-year-old urban viaduct

Experimental Study and Residual Performance Evaluation of Corroded High-Tensile Steel Wires

Static Shear Performance and Residual Axial Capacity of Rectangular RC Bridge Piers under Near-Ground Lateral Loads

Performance Monitoring of Damaged Bridge Members Strengthened with Carbon Fiber Reinforced Polymer

Crack Propagation and Flexural Behaviour of Rc Beams under Simultaneous Sustained Loading and Steel Corrosion

Hydrogen-assisted cracking and damage tolerance of high-strength lath-martensite steel bars for structural applications

Field investigation and numerical analysis of horizontal cracking in ledge girders of post-tension concrete bridges

Effect of structural repairs on the load rating and reliability of a prestressed concrete bridge

Investigation of the unusual deformations of external tendons in concrete highway bridges

A Combined Experimental-Numerical Framework for Assessing the Load-Bearing Capacity of Existing PC Bridge Decks Accounting for Corrosion of Prestressing Strands

The Collapse of the Morandi’s Bridge: Remarks About Fatigue and Corrosion

Intensity and location of corrosion on the reliability of a steel bridge

Post-collapse Analysis of Morandi’s Polcevera Viaduct in Genoa Italy

Structural performance of reinforced concrete beams subjected to combined effects of corrosion and cyclic loading

Experimental Study on Shear Performance of Post-Tensioning Prestressed Concrete Beams with Locally Corroded Steel Strands

An integrated material-structural analysis of prestress concrete affected by corrosion of non-prestressed reinforcement

Improving the Structural Reliability of Steel Frames Using Posttensioned Connections

Flexural behavior of Corrosion-Damaged prestressed concrete beams

Effect of Local Bond Behavior Degradation on Tension Stiffness in Reinforced Concrete with Pre-existing Longitudinal Cracks

Rückverankerung beim Durchtrennen historischer Spannglieder

Monitoring tendon breaks in concrete structures at different depths using distributed fiber optical sensors