Urea-based fuel cells on paper with micro-watt power generation to drive low power circuits

Sai Krishna,Sweta Lal,Suyash Shrivastva,Pydi Ganga Bahubalindruni

DOI: https://doi.org/10.1007/s10800-024-02105-z

IF: 2.925

2024-03-05

Journal of Applied Electrochemistry

Abstract:This work demonstrates the application of urea-powered paper-based fuel cells (PFCs) with Hydrogen Peroxide (H 2 O 2 ) as the oxidant to drive a flexible electronic circuit (ring oscillator (RO)), for the first time. Herein, the electrochemical performance of four different PFCs has been studied by employing non-precious electrodes as the anode and cathode. These are the membraneless PFC with (i) Toray carbon paper (CP) (ii) Nickel (Ni)-mesh (iii) Nickel Cobalt nanoparticles supported on reduced Graphene Oxide loaded on the CP (Ni Co@rGo@CP) and (iv) membrane-based PFC with Ni Co@rGo@CP as the electrodes. In each PFC the same electrode is employed on both the sides. A single membraneless-PFC with Ni-Co@rGo@CP as electrodes delivered a peak power density (P max ) of 55 μW cm −2 , maximum current density (J max ) of 371 μA cm −2 and an open-circuit voltage (OCV) of 0.7 V at 3 M urea. While, a single membrane-based PFC assembled on an anion exchange membrane with Ni-Co@rGo@CP electrodes, delivered a P max of ≈70 μW cm −2 and J max of ≈500 μA cm −2 at an OCV of 0.7 V with 3 M urea. Subsequently, a stack of two membrane-based PFCs delivered an OCV of ≈1.4 V for 400 s. Finally, this stack is employed as a power source to drive a RO. The measured frequency and peak-to-peak voltage are 37.52 kHz and 1.04 V, respectively. This demonstration opens a window to implement self-contained flexible electronic system using PFCs as the power source with minimal e-waste.

electrochemistry