Physico-chemical properties of pristine graphene and its performance as electrode material for electro-Fenton treatment of wastewater

Emmanuel Mousset,Zuxin Wang,Joshua Hammaker,Olivier Lefebvre

DOI: https://doi.org/10.1016/j.electacta.2016.08.002

IF: 6.6

2016-10-01

Electrochimica Acta

Abstract:This paper reports for the first time the performance of pristine graphene – in the form of graphene monolayer (Gmono), graphene multilayer (Gmulti) and graphene foam (Gfoam) – as cathode material in an electrochemical advanced oxidation process known as electro-Fenton (EF) for wastewater treatment. This study led to three major findings: (i) the electrogeneration of H2O2 was proven feasible with the three graphene materials at an optimal cathodic potential (E cat) (−0.6V vs Ag/AgCl) comparable to that obtained with other carbon-based cathodes such as graphite and carbon felt (Cfelt); (ii) for all forms of graphene, the Fe2+ regeneration rate and the H2O2 production yield were sufficient to sustain the formation of OH through the Fenton reaction, leading to the degradation and mineralization of phenol, used as a model pollutant and; (iii) over the 3 graphene materials, Gfoam exhibited the highest H2O2 electrogeneration yield (4.25mg-H2O2 L−1 cm−3), degradation rate (0.0081min−1) and yield (78% after 3h), mineralization rate (0.0818h−1) and yield (50% after 8h). The superiority of Gfoam was attributed to its high purity (I(2D)/I(G)=1.58, C1s/O1S=22), low interfacial charge-transfer resistance (R ct) (1.6Ω), high electroactive surface area (55.017cm2) and three-dimensional (3D) porous structure (100–600μm pore diameter), allowing it to outcompete conventional 3D carbon-based cathode materials in terms of efficiency and energy requirements. These results open up the possibility to use pristine graphene in EF for the treatment of wastewater.

electrochemistry