Two-Dimensional SnSe Composited with One-Dimensional Mn Nanowires: A Promising Thermoelectric with Ultrahigh Power Factor

Y. F. Li,G. H. Tang,Bo Fu,Min Zhang,Xin Zhao

DOI: https://doi.org/10.1021/acsaem.0c01591

IF: 6.4

2020-08-26

ACS Applied Energy Materials

Abstract:Two-dimensional (2D) SnSe is a promising candidate for thermoelectric applications. In this work, we have explored an optimization strategy for thermoelectric conversion in two-dimensional monolayer SnSe by compositing with one-dimensional (1D) Mn nanowires. The thermoelectric properties were investigated using the first-principles theory calculation combined with the Boltzmann transport theory. The proposed 2D–1D composite structure can regulate the band gap and the degeneracy by changing the distance between 1D Mn nanowires. It was found that the carrier mobility can be increased to a maximum of 8143.26 cm² V^–1 s^–1 at 300 K due to the reduced electron–phonon scattering effect. In addition, high band degeneracy and high carrier mobility lead to an ultrahigh power factor of 200 μW cm^–1 K^–2 in 3Mn–SnSe at 300 K, which can compensate for the negative effect of high electronic thermal conductivity. As a result, record high <i>ZT</i> values from 0.73 at 200 K to 3.78 at 650 K are achieved in 3Mn–SnSe, 39.2% larger than the <i>ZT</i> values of the pristine monolayer SnSe on average. This work presents an effective structural modification strategy to optimize the thermoelectric performance of 2D SnSe, with the potential of extension to other low-dimensional thermoelectric materials.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsaem.0c01591?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsaem.0c01591</a>.Atomic orbital projection band structure, projection of electronic energy in the first Brillouin zone, charge density distribution, thermoelectric parameters at the carrier concentration between 10⁹ and 10¹² cm^–2, and detailed parameters employed in deformation potential theory calculations (<a class="ext-link" href="/doi/suppl/10.1021/acsaem.0c01591/suppl_file/ae0c01591_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

materials science, multidisciplinary,chemistry, physical,energy & fuels

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to optimize the thermoelectric properties of two - dimensional (2D) single - layer SnSe by compounding it with one - dimensional (1D) Mn nanowires. Specifically, the research aims to:

1. **Improve thermoelectric conversion efficiency**: By designing a 2D - 1D composite structure, adjust the band gap and degeneracy, thereby optimizing the electron transport characteristics, especially increasing the carrier mobility and power factor ($S^2\sigma$), and ultimately increasing the thermoelectric figure of merit (ZT value).

2. **Reduce thermal conductivity**: By introducing Mn nanowires to enhance the phonon scattering effect and reduce the lattice thermal conductivity ($\kappa_l$), thereby further increasing the ZT value.

3. **Explore new material modification strategies**: Propose an effective atomic - scale structural modification strategy to optimize the performance of low - dimensional thermoelectric materials. This is applicable not only to SnSe but may also be extended to other low - dimensional thermoelectric materials.

### Main findings:
- **Increase in carrier mobility**: At 300 K, the carrier mobility can reach up to 8143.26 cm² V⁻¹ s⁻¹, which is due to the reduction of electron - phonon scattering effects.
- **Ultra - high power factor**: At 300 K, the power factor of 3Mn - SnSe reaches 200 μW cm⁻¹ K⁻², which can compensate for the negative impact of high electron thermal conductivity.
- **Significantly increased ZT value**: In 3Mn - SnSe, the ZT value increases from 0.73 at 200 K to 3.78 at 650 K, with an average increase of 39.2% compared to pure single - layer SnSe.

### Research methods:
- **Density functional theory (DFT)**: Used to calculate geometric structures, electronic and phonon properties.
- **Boltzmann transport equation (BTE)**: Combined with the relaxation time approximation (RTA) method to calculate electron transport properties such as Seebeck coefficient, electrical conductivity and electron thermal conductivity.
- **Debye - Callaway model**: Used to calculate lattice thermal conductivity, taking into account multiple phonon scattering mechanisms, including normal scattering, Umklapp scattering, boundary scattering and defect scattering.

### Conclusion:
This research successfully optimizes the thermoelectric properties of single - layer SnSe through the design of a 2D - 1D composite structure, demonstrating an effective way to achieve high - performance thermoelectric conversion in low - dimensional thermoelectric materials. This strategy is applicable not only to SnSe but may also be extended to other low - dimensional thermoelectric materials.