Abstract:In food, chemicals and pharmaceuticals industries, the concentration is a very important parameter for quality control. Continuous process monitoring is a fundamental requirement for the process control in these industries. Besides process parameters, such as temperature, pressure, liquid level, flow rate, concentration measurement is also of special interest. More qualified information obtained from new or better sensors can significantly enhance the process quality and thereby product properties. Low-intensity ultrasonic sensor system can contribute to this development, and it has been widely used in many fields for its characteristics are non-destructive, non-invasive and rapid. In this study, a method based on ultrasound for determining the concentration of NaCl water solution with high accuracy was presented. The ultrasound velocity in different temperatures and in solutions with different concentrations was measured using an emitter-receiver method. The experimental set-up was composed of two matched piezoelectric transducers with the center frequency of around 5 MHz (one used as emitter and the other as receiver), a thermostatic tank, a CTS-80787PR pulse emitter-receiver (used to excite and receive electric signals) and a data acquisition card. The electric pulse at the emitting voltage of-25 V, the width of 100 ns and the repeated frequency of 100 Hz was sent from the CTS-80787PR to the emitter transducer and then transformed to ultrasound wave. This wave traveled through a liquid sample cell with 5 mm wide to reach the receiving transducer, and was transformed back to electric pulse signal. The signal was acquired by the CTS-80787PR and sent to a computer equipped with the LABVIEW via a 16-bit data acquisition card of PCI (peripheral component interconnect) bus with the sampling rate of 40 MS/s. A Labview interface was developed to collect signals, analyze signals, build models and validate models. Through analysis, the measurement accuracy of ultrasound velocity was 1 m/s for this equipment, which ensured the accuracy of concentration measurement. At 2.5°C gradient in the temperature range of 10-30°C, and at a gradient of 0.5 g/100 g in the concentration range of 0-10 g/100 g, NaCl water solutions were prepared. Some were regarded as calibration samples and others as validation samples. In order to predict the concentrations of NaCl water solution, a calibration model was established using a quadratic polynomial approach based on the experimental results. The coefficients of this polynomial were obtained based on ordinary multiple linear regression (OMLR) method by inserting the measurement points, analyzing the residual to eliminate abnormal sample points and checking out the regression coefficient of the model by t-test. The developed model had high prediction accuracy and stability with the maximum prediction error of 0.25 g/100 g, the determination coefficient of calibration (Rcal2) of 0.9992, the determination coefficient of validation (Rval2) of 0.9988, the root mean square error of calibration (RMSEC) of 0.0894 g/100 g, the root mean square error of prediction (RMSEP) of 0.1015 g/100 g and the ratio performance deviation (RPD) of 28.57, which indicated that the model could be used for practical detection accurately and steadily, and was helpful for on-line measuring.

Gas concentration measurment using ultrasonic

A Model-Based Transit-Time Ultrasonic Gas Flowrate Measurement Method

Theory for a gas composition sensor based on acoustic properties

Measuring Sound Speed in Gas Mixtures Using a Photoacoustic Generator

Calibration-free wavelength modulation spectroscopy for gas concentration measurements under low-absorbance conditions

Ultrasonic gas flow metering in hydrogen-mixed natural gas using Lamb waves

Implementation of ultrasonic sensing for high resolution measurement of binary gas mixture fractions

Simultaneous Measurement of SO 2 and NO 2 Concentration Using an Optical Fiber-Based LP-DOAS System

TECHNIQUE FOR MEASURING CONCENTRATION OF GAS - SOLID TWO - PHASE FLOW INSIDE THE PIPE BASED ON ULTRASONIC METHOD

Acoustic sensor for determining combustion properties of natural gas

Experimental Research on Measuring the Concentration of CO2 in Gas-Liquid Solution Based on PZT Piezoelectric-Photoacoustic Spectroscopy

[Ammonia gas concentration and velocity measurement using tunable diode laser absorption spectroscopy and optical signal cross-correlation method].

Half-width integral method for gas concentration measuring in tunable diode laser absorption spectroscopy

Calibration-free Optical Emission Spectroscopy Method for the Measurements of Gas Temperature and OH Density

Audible sensing of low-ppm concentration gases

Identifying gas composition based on the decomposed relaxation strength from sound-speed dispersion

A non-intrusive measurement technique applying CARS for concentration measurement in a gas mixing flow

Design and test of high accurately measuring equipment for NaCl water solution utilizing ultrasonic velocity with temperature correction

Joint measurement of cosmic-ray muons and seismic waves at laboratory scale

Modelling of ultrasonic method for measuring gas holdup of Oil-Gas-Water three phase flows