Abstract:Journal of Circuits, Systems and Computers, Ahead of Print. This paper presents an innovative general structure for a single-loop Sigma-Delta ([math]) modulator that combines low-distortion and noise-coupled techniques to achieve high-resolution for low-power applications. The low-distortion technique adjusts the signal transfer function of the proposed structure to unity, while the noise-coupled technique enhances the order of quantization noise-shaping at the modulator output. These techniques were incorporated into the design to increase the modulator order without requiring additional operational amplifiers during its circuit implementation, resulting in a low-power modulator compared to similar structures. To reduce the number of required amplifiers, a second-order infinite impulse response (IIR) filter was used in the modulator loop filter, in place of two integrators. To assess the proposed structure's performance, a third-order modulator sample was implemented and simulated for speech recognition applications, specifically, digital hearing aids, using 180[math]nm complementary metal oxide semiconductor (CMOS) technology. The results indicate that for a third structure with a sampling rate of 64, an input sine signal of −6[math]dBFS and a sampling frequency of 2.56[math]MHz, the signal to noise plus distortion (SNDR) was 81.9[math]dB, and the dynamic range (DR) was 88[math]dB for a 20[math]KHz bandwidth. The modulator's power consumption was 126.9[math][math]W. Circuit and system-level simulations demonstrate the effectiveness of the proposed method.

A Dual-Mode Continuous–Time Sigma-Delta Modulator With a Reconfigurable Loop Filter Based on a Single Op-Amp Resonator

A Sigma-Delta Modulator with Residual Offset Suppression

Low-power High-Linearity Sigma-Delta Modulator for Audio Applications

A High-Performance,Low-Power ΣΔ Modulator for Digital Audio Applications

Modeling of a 200 KHz Bandwidth Low-pass Switch-capacitor Sigma-delta DAC with a Raised Spur-free Modulator

A 20mhz BW 35fj/conv. Continuous-Time ΣΔ Modulator with Single-Opamp Resonator Using Finite GBW Compensation Method.

Design of a Dual-Mode Configurable Delta-Sigma Modulator

A Low-power High-resolution Sigma-Delta Modulator

Low power latched comparator based second order sigma delta modulator (SDM)

A 77.1db/108.9db Sndr Dual-Mode Delta-Sigma Modulator

0.9 V 58 Μw 92 Db SNDR Audio ΔΣ Modulator with High Efficiency Low Noise Switched-Opamp and Novel DWA Technique

A 9 Mu W 88db Dr Fully-Clocked Switched-Opamp Delta Sigma Modulator With Novel Power And Area Efficient Resonator

A 18-Mw, 20-Mhz Bandwidth, 12-Bit Continuous-Time Σ Δ Modulator Using a Power-Efficient Multi-Stage Amplifier

A 1.44-mW 96-dB SNR Sigma-Delta modulator with low-power OPAMP

A Low Power Low Voltage 16 Bit Audio SigmaDelta Modulator.

A Flexible Continuous-Time $\delta \sigma $ ADC with Programmable Bandwidth Supporting Low-Pass and Complex Bandpass Architectures

A 20 Mw 12-Bit Continuous-Time Σ-Δ Modulator with 5 MHz Signal Bandwidth

Dual-mode 10mhz BW 4.8/6.3mw Reconfigurable Lowpass/complex Bandpass CT &#x03a3;&#x0394; Modulator with 65.8/74.2db DR for a Zero/low-if SDR Receiver

A Novel Approach for Realizing Loop-Filter in Low-Distortion Noise-Coupled [math] Modulators

A 9µW 88dB DR fully-clocked switched-opamp ΔΣ modulator with novel power and area efficient resonator

A Double-Sampling 38-Μw 92-Db Sigma-Delta Modulator with 8-Khz Signal Bandwidth