High-Throughput Nanocapillary Filling Enabled by Microwave Radiation for Scanning Ion Conductance Microscopy Imaging
Vytautas Navikas,Sanjin Marion,Sebastian James Davis,Barney Drake,Georg E. Fantner,Aleksandra Radenovic,Samuel M. Leitão
DOI: https://doi.org/10.1021/acsanm.0c01345
IF: 6.14
2020-07-02
ACS Applied Nano Materials
Abstract:Solid-state nanopores provide a highly sensitive tool for single-molecule sensing and probing nanofluidic effects in solutions. Glass nanopipettes are a cheap and robust type of solid-state nanopore produced from pulling glass capillaries with opening orifice diameters down to below tens of nanometers. Sub-50 nm nanocapillaries allow an unprecedented resolution for translocating single molecules or for scanning ion conductance microscopy imaging. Due to the small opening orifice diameters, such nanocapillaries are difficult to fill with solutions, compromising their advantages of low cost, availability, and experimental simplicity. We present a simple and cheap method to reliably fill nanocapillaries down to sub-10 nm diameters by microwave radiation heating. Using a large statistic of filled nanocapillaries, we determine the filling efficiency and physical principle of the filling process using sub-50 nm quartz nanocapillaries. Finally, we have used multiple nanocapillaries filled by our method for high-resolution scanning ion conductance microscopy imaging.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsanm.0c01345?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsanm.0c01345</a>.Nanocapillary pulling parameters (Table S1), nanocapillary filling dynamics and <i>IV</i> curves of filmed nanocapillaries (Figure S1), nanocapillary filling with high-viscosity solutions (Figure S2), schematics of a chamber used for direct imaging of the nanocapillary filling process (Figure S3), brightfield microscopy characterization of nanocapillaries before and after microwave-induced filling (Figure S4), schematics of the electrical signal measurement setup (Figure S5), RMS noise and power spectral densities of measured nanocapillaries (Figure S6), and SEM images of the nanocapillaries and corresponding <i>IV</i> curves (Figure S7) (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.0c01345/suppl_file/an0c01345_si_001.pdf">PDF</a>)Video of filling of capillaries (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.0c01345/suppl_file/an0c01345_si_002.mp4">MP4</a>)Video of filling with 50% glycerol 400 mM KCl solution (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.0c01345/suppl_file/an0c01345_si_003.mp4">MP4</a>)This article has not yet been cited by other publications.
materials science, multidisciplinary,nanoscience & nanotechnology