Well-Dispersed CoNiO2 Nanosheet/CoNi Nanocrystal Arrays Anchored onto Monolayer MXene for Superior Electromagnetic Absorption at Low Frequencies

Leiyu Du,Renxin Xu,Yunfa Si,Wei Zhao,Hongyi Luo,Wei Jin,Dan Liu

DOI: https://doi.org/10.3390/coatings14050631

IF: 3.236

2024-05-17

Coatings

Abstract:Developing microwave absorbers with superior low-frequency electromagnetic wave absorption properties is one of the foremost important factors driving the boom in 5G technology development. In this study, via a simple hydrothermal and pyrolysis strategy, randomly interleaved CoNiO2 nanosheets and uniformly ultrafine CoNi nanocrystals are anchored onto both sides of a single-layered MXene. The absorption mechanism demonstrated that the hierarchical heterostructure prevents the aggregation of MXene nanoflakes and magnetic crystallites. In addition, the introduction of the double-magnetic phase of CoNiO2/CoNi arrays can not only enhance the magnetic loss capacity but also generate larger void spaces and abundant heterogeneous interfaces, collectively promoting impedance-matching and furthering microwave attenuation capabilities at a low frequency. Hence, the reflection loss of the optimal absorber (M–MCNO) is −45.33 dB at 3.24 GHz, which corresponds to a matching thickness of 5.0 mm. Moreover, its EAB can entirely cover the S-band and C-band by tailoring the matching thickness from 2 to 7 mm. Satellite radar cross-section (RCS) simulations demonstrated that the M–MCNO can reduce the RCS value to below −10 dB m2 over a multi-angle range. Thus, the proposed hybrid absorber is of great significance for the development of magnetized MXene composites with superior low-frequency microwave absorption properties.

materials science, multidisciplinary,physics, applied, coatings & films

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to develop microwave - absorbing materials with superior electromagnetic wave - absorbing properties in the low - frequency range. With the development of 5G communication technology, the negative impacts of electromagnetic pollution on human health and surrounding electronic devices are receiving increasing attention. In order to effectively address this issue, researchers have taken many measures to develop emerging low - frequency microwave - absorbing materials (MAMs), such as magnetic - loss absorbers, dielectric - loss absorbers and their composites. Among them, MXene, due to its two - dimensional structure, has excellent conductive - loss and significant polarization - loss characteristics and plays an important role in high - performance low - frequency MAMs. However, due to the high dielectric constant and almost negligible permeability of MXene materials, it results in serious impedance mismatch, causing electromagnetic waves to be reflected on the material surface instead of penetrating into the interior to be effectively attenuated, which significantly reduces the microwave - absorbing ability. Therefore, developing low - frequency MXene - based MAMs with perfect impedance matching is a major responsibility and challenge.

To solve the above problems, this paper proposes a simple hydrothermal and pyrolysis strategy to anchor randomly interlaced CoNiO_2 nanosheets and uniformly ultrafine CoNi nanocrystals on a single - layer MXene to construct a composite material with superior low - frequency electromagnetic wave - absorbing properties. This composite material can not only prevent the aggregation of MXene nanosheets and magnetic grains, but also enhance the magnetic - loss ability by introducing a dual - magnetic - phase (CoNiO_2/CoNi array) and generate larger void spaces and rich heterogeneous interfaces, which jointly promote impedance matching and further improve the microwave - attenuation ability at low frequencies. The experimental results show that the optimal absorber (M - MCNO) has a reflection loss of - 45.33 dB at 3.24 GHz, corresponding to a matching thickness of 5.0 mm. In addition, by adjusting the matching thickness from 2 to 7 mm, its effective absorption bandwidth (EAB) can completely cover the S - band and C - band. Satellite radar cross - section (RCS) simulations show that M - MCNO can reduce the RCS value to below - 10 dB m^2 in a multi - angle range. Therefore, the proposed hybrid absorber is of great significance for developing magnetized MXene composites with superior low - frequency microwave - absorbing properties.