Abstract:Power transformers represent an important part of the capital investment in transmission and distribution substations. The cooling of the windings (electrical coil) depends on the convection of heat, enhanced by the forced circulation of oil through the windings and heat exchangers. The forced circulation of oil combined with the forced circulation of air in the heat exchangers is usually found in mobile transformers, whose compact structure is a challenge in terms of heat transfer rates. An improper design or fabrication problem associated with the assembling of the cooling system may result in an inefficient exchange of heat, which may lead to transformer failure from overheating or a reduction of the life span. In this context, the present work proposes a 2D mathematical model to simulate the winding cooling system of a 138 × 69–34 × 13.8 kV 25 MVA Mobile Power Transformer with the objective of investigating the causes of overheating. The model is implemented in CFD Ansys-Fluent® version 17.0 and validated with experimental data. It is evaluated the velocity and temperature distribution, and the identification of the hot spots on the transformer operating considering the nominal conditions for oil flow rate, inlet temperature, and power dissipated. The hot spot temperatures are compared with the current Brazilian Association of Technical Standards—NBR 5356-2: 2007 Power Transformers Part 2: Heating. After, some geometric and/or operational constraints are artificially imposed on the transformer. Their impact on the velocity and temperature fields, as well as the hot spot temperatures, are mapped in order to verify if they still respect the standard ́s temperature limits and if imposed constraints may lead to the transformer failure. The numerical results clearly illustrate that geometric imperfections in the disks, guides, or axial cooling ducts have a direct impact on oil flow and temperature distributions. These imperfections can also alter the positioning and significantly increase the temperature of the hottest spot within the winding, sometimes even exceeding the requirements of the ABNT NBR 5356:2 standard in certain scenarios. Therefore, the proposed mathematical model serves as a valuable tool for investigating a complex and common issue within the energy distribution system. This issue not only inconveniences the population but also leads to economic challenges each year. Finally, the outcomes of this study can provide engineers with essential insights to enhance the thermal design of power transformers, as well it can assist in guiding maintenance efforts and understanding the root causes of new failures.

Simulation Study on Acetylene Gas Diffusion Process in Large Transformers

Numerical Simulation on the Leakage and Diffusion of Hydrogen in Indoor Environment

Development of an Online Detection Setup for Dissolved Gas in Transformer Insulating Oil

Diffusion Mechanisms of Dissolved Gases in Transformer Oil Influenced with Moisture Based on Molecular Dynamics Simulation

Simulation and Analysis of Transformer Oil Interface Discharge under DC Voltage

Analysis of Abnormal Detection Data of Dissolved Gases in 500kV Transformer Oil

Research on Oil Pressure Rise and Fluctuation Due to Arcing Faults Inside Transformers

Simulation and Analysis of Pressure Generation Characteristics Caused by Arcing Faults in Transformer

Quantitative Analysis of Natural Gas Diffusion Characteristics in Tight Oil Reservoirs Based on Experimental and Numerical Simulation Methods

Quantification of preferential and mutual mass transfer of gases-light oil systems at high pressures and elevated temperatures by dynamic volume analysis

Numerical simulation and experimental study of gas diffusion in a ship engine room

Numerical Simulation Study on the Diffusion Characteristics of High-Pressure Hydrogen Gas Leakage in Confined Spaces

On The Structure Of Nonsooting Counterflow Ethylene And Acetylene Diffusion Flames

Experiments and numerical simulation on soot formation in opposed-jet ethylene diffusion flames

Numerical evaluation of the directed oil cooling system of a mobile power transformer

Numerical Simulation on the Diffusion of Hydrogen Due to High Pressured Storage Tanks Failure

The molecular dynamic simulation investigation of the dispersion stability of nano-modified transformer oil

Method for Measuring Thermal Flow Field Distribution in Oil-Immersed Transformer Using Dynamic Heat Transfer Coefficient

Magnetic-Thermal-Flow Field Coupling Simulation of Oil-Immersed Transformer

Streaming Electrification Measurement and Electric Field Simulation in Oil Duct of Power Transformer

Simulation Study on Dynamic Characteristics of Bubbles in Transformer Oil under Extremely Nonuniform Field