Abstract:Heat transfer methods aim to maximize heat transmission and minimize pressure loss. Published efforts have focused on active and passive heat transport techniques. Curved tubes, such those in helical coil heat exchangers, improve heat transmission without active intervention. Experimental and computational studies of helical coils under forced convection have been done. This work examined the heat transmission and pressure drop of forced convection helical coil tubes using experimental and CFD methods. CATIA V5 builds, ICEM 14.5 meshes, and ANSYS 14.5 solves a three-dimensional model. A k-turbulent flow model and algorithm simulate fluid flow and heat transfer to properly predict heat transfer characteristics. Experiments and computer simulations determined the temperature and pressure loss at a particular flow rate and input temperature. The model is validated by comparing numerical simulation temperature differences to experimental data. A boundary condition that maintains a constant temperature in numerical analysis may provide incorrect results. This makes the boundary condition a connected system. To calculate temperature, a K-turbulence model (RNG) solver is used with curvature correction and swirl dominated flow. The project includes turning a 12-mm straight tube into a 120-mm helical coil with a 25-mm pitch. To simulate forced convection, this coil is placed in a duct. Experiment is done at 353 K and 343 K with 1.23, 1.66, and 2.1 l/min flow rates. The CFD simulation used the same design and flow conditions. One end of the duct has a fan that blows air over the coil and lets hot water run through it. With a constant wall temperature as the boundary condition, the conjugate heat transfer between the water and air in the coil and fan is examined in a cross flow pattern. Different flow rates were used to validate temperature difference data. The experimental and CFD values varied by 7% or less due to measurement errors in system temperature and heat losses.

SIMULATION ANALYSIS OF SHELL AND TUBE HEAT EXCHANGER USING DIFFERENT FLUIDS

Numerical Analysis of Heat Transfer Characteristics of a Falling Film Type Plate-Fin Condenser/Reboiler

Thermal analysis and performance investigations of shell and tube heat exchanger using numerical simulations

Analysis of the performance optimisation parameters of shell and tube heat exchanger using CFD

Numerical Simulation of Heat Transfer on the Shell Side in Water Cooler with Helical coil

Numerical Simulation of Heat Transfer in Finned Tube of Heat Recovery Unit Using Fluid-Solid Coupled Method

Numerical Modeling and Experimental Validation of Heat Transfer and Flow Resistance on the Shell Side of a Shell-and-tube Heat Exchanger with Flower Baffles

Thermal analysis, pressure drop and exergy loss of energy efficient shell, and triple meshed helical coil tube heat exchanger

Process Parameters Analysis of Ethylene Glycol-Water and Air-Glycol System in Shell and Tube Heat Exchanger

Design, Fabrication and Performance Evaluation of a Shell and Tube Heat Exchanger for Practical Application

HEAT EXCHANGER DESIGN OPTIMISATION

Simulation Performance Analysis of Shell and Tube Heat Exchanger Using Comsol Multiphysics 5.6 Software

Exergy analysis of Shell and helical coil heat exchanger and design optimization

PERFORMANCE SIMULATION ON THE SHELL AND TUBE OF HEAT EXCHANGER BY ASPEN HYSYS V.10

NUMERICAL INVESTIGATION ON HEAT STORAGE AND HEAT EXCHANGE OF THE SHELL-AND-TUBE PHASE CHANGE HEAT EXCHANGER

Modeling of a Condenser in Dynamic Operation Using Comsol Multiphysics Software

Thermodynamic and hydraulic design characteristics of the fin tube heat exchanger

DESIGN AND SIMULATION OF SHELL-AND-TUBE HEAT EXCHANGER (STHE) WITH THE EFFECT OF BAFFLES USING CFD-TOOL

Numerical Simulation and Analysis of Performance of Fin-and-tube Heat Exchanger with Complex Circuit Arrangement

Progress in Design Calculations of Shell-and-tube Heat Exchangers

Evaluation of a helical coil heat exchanger in a forced convection environment