Abstract:In the future, wind turbine blade waste will increase significantly. However, there is no proper treatment plan for this condition. Pyrolysis is one of the most feasible methods for recycling waste wind turbine blades. In this paper, the thermal degradation behaviors of epoxy resin mixed with carbon fiber applied in wind turbine blade base components were studied by thermogravimetric analysis, thermogravimetric-Fourier transform infrared spectroscopy and tube furnace. The effects of different heating rates and mixing ratios were investigated, the kinetics of the pyrolysis reaction were calculated in detail, and the composition of the pyrolysis volatile fraction was studied. The results showed that increasing the heating rate was more favorable for the pyrolysis characteristics of mixed samples. However, it would reduce the degree of pyrolysis, showing a different pattern from that of the pure epoxy resin. The activation energy of pyrolysis was calculated by the Coats and Redfern method and Flynn–Wall–Ozawa method, and the effects of the mixing ratio on the activation energies of the samples were greater than those of the heating rate. During the thermal decomposition of the sample, mainly carbon–oxygen compounds, methane, alkanes, olefins, carboxylic acids and aromatic compounds were produced. The pyrolysis of the mixture could be divided into three steps based on the product characteristics combined with kinetic calculation results. According to the tube furnace results, the best calorific value and recovery value of gaseous products are obtained with the sample proportion closest to the actual component. In general, the copyrolysis of carbon fiber and epoxy resin is much more complicated than that of epoxy resin alone, and the addition of carbon fiber eases the epoxy resin pyrolysis process, which does not exclude the existence of synergistic effects in the pyrolysis process; additionally, the difference in pyrolysis behavior is greater under different mixing ratios. Based on this phenomenon, basic data support was provided for further research on the pyrolysis and recycling process of waste wind turbine blades.

Study on the characteristics of glass fiber‐reinforced polymers from recycled wind turbine blades as reinforcement in particleboard

Possibility of Using Wind Turbine Waste in Particleboard Manufacturing

Recycling of waste wind turbine blades for high‐performance polypropylene composites

The Impact of Wood Fibers in Composite Panels Made from Recycled Fiberglass Wind Turbine Blades

The Recycling of Comminuted Glass-Fiber-Reinforced Resin from Electronic Waste

A study on the characteristics and thermal properties of modified regenerated carbon fiber reinforced thermoplastic composite recycled from waste wind turbine blade spar

Recycling Polyurethane Materials to Improve Properties of Wood Composite Panels

Recycled wind turbine blades as a feedstock for second generation composites

Mechanical Properties and Microscopic Study of Recycled Fibre Concrete Based on Wind Turbine Blades

Recycling of Mechanically Ground Wind Turbine Blades as Filler in Geopolymer Composite

A recyclable epoxy for composite wind turbine blades

Supporting Circular Economy Principles by Recycling Window Frames into Particleboard

Preparation Process of Particleboard with Solid Waste from Waste Paper Pulping

The Effect of GFRP Powder on the High and Low-Temperature Properties of Asphalt Mastic

Experimental Study and Process Simulation on Pyrolysis Characteristics of Decommissioned Wind Turbine Blades

Recycling Glass Fiber from Polyurethane Composite by Pyrolysis Strategy with High Mechanical Properties

Study on isothermal pyrolysis and product characteristics of basic components of waste wind turbine blades

Study on recycling wind turbine blades into reinforcement for filaments used in 3D printing

Collaborative Disposal of Exhaust Gases and Wasted Wind Turbine Blades: Mechanical Properties of Recycled Glass Fibres and Economic Analysis

Surface-Treated Recycling Fibers from Wind Turbine Blades as Reinforcement for Waste Phosphogypsum

Analysis of the pyrolysis process, kinetics and products of the base components of waste wind turbine blades (epoxy resin and carbon fiber)