Abstract:Silver (Ag)‐doped PbS (PbS:Ag) thin films of 616 to 745 nm in thickness were prepared on glass substrates via cost‐effective nebulizer spray method by adding different Ag levels from 2% to 8% at 200°C. For solar cell applications, the effect of Ag doping concentration on structural, morphological, optical, photoluminescence, and electrical chattels of PbS thin film has been studied. X‐ray diffraction pattern confirmed the polycrystalline behavior of the prepared PbS:Ag films with cubic crystalline nature. The crystalline size and texture coefficient were increased by increasing Ag doping concentration. From the morphological studies by scanning electron microscope (SEM) and atomic force microscope (AFM), the grain size of the films and surface roughness values were increased for the increase in Ag doping concentration. EDS spectra confirmed the existence of Ag, Pb, and S elements in the select 6% Ag‐doped PbS film. Peaks related to silver oxide started to emerge at 6% of Ag doping level. The optical direct band gap value was reduced from 1.51 to 1.17 eV for Ag doping from 2% to 6% and thereby slightly increased as 1.79 eV for 8% Ag doping level. For all PbS:Ag films, the photoluminescence spectrum emitted a strong near band edge (NBE) emission at approximately 580 nm, meaning better optical quality. Hall effect measurements evidenced that Ag doping provides enhancement on the characteristics of mobility, carrier concentration, and resistivity with p‐type conducting nature. The observed high carrier concentration and low resistivity values were 4.32 × 1014 cm−3 and 80 Ωcm, for 6% Ag‐doped PbS film. The FTO/CdS/PbS:Ag heterostructure solar cell was formed from 6% Ag‐doped film.

The impact of silver incorporation on the structural, morphological, and optical properties of spray-pyrolyzed cubic SnS thin films

[Study of the Physical Properties of SnS Thin Films Deposited by Ultrasonic Spray Pyrolysis Method].

Structural/microstructural, optical and electrical investigations of Sb-SnO2 thin films deposited by spray pyrolysis

Effect of Incorporation of Silver on the Electrical Properties of Sol-Gel-Derived Titania Film

Photo sensing characteristics of Ag doped Sn2S3 thin films grown by economic nebulizer spray pyrolysis technique

Effect of the impurity in electroless plated Powders on morphology and properties of sintered AgSnO2 materials

SnS Films for Photovoltaic Applications: Physical Investigations on Sprayed SnxSy Films

The Nanostructure Based SnS Chalcogenide Semiconductor: A Detailed Investigation of Physical and Electrical Properties

Influences of Tin Oxide Surface Modification on the Morphology and Performance of Sintered Ag/SnO2 Composite Powders

Impact of Silver Incorporation and Flash-Lamp-Annealing on the Photocatalytic Response of Sputtered ZnO Films

Structural, optical and electrical properties of Ag doped PbS thin films: role of Ag concentration

Optical behaviour of sprayed tin sulphide thin films

In-depth characterization of physical proprieties of SnS:Mg thin films fabricated by ultrasonic spray for solar cell applications

Co-electrodeposited Ag2SnS3/Mo thin films: optical and electrochemical study: DFT complement

Role of Sm in tuning the third-order nonlinear optical properties of spray coated Sn1-xSmxO2 films

Investigations on SnS films deposited by spray pyrolysis

Ag‐doped PbS thin films by nebulizer spray pyrolysis for solar cells

Chemically Synthesized Ag-Doped Sns Films for Pv Applications

Influence of Different Substrates on the Properties of Sulfurized Sns Films

Preparation and characterisation of sprayed tin sulphide films grown at different precursor concentrations

Tailoring the structural, optical, and optoelectrical properties of innovative n-type Ag2ZnSnS4 thin films and investigating ITO/Ag2ZnSnS4/SnS/Au heterojunction