Subband digital predistorsion based on Indirect Learning Architecture

Mazen Abi-Hussein,O. Venard

DOI: https://doi.org/10.1109/ICASSP.2014.6855153

2014-05-04

Abstract:This paper deals with the linearization of RF power amplifiers (PAs) using digital predistortion (DPD) technique. One of the most important constraint on DPD implementation is digitization of PA output signal needed for identification of predistorter model. The bandwidth of this signal may be 3 to 7 times wider than the bandwidth of the input signal. The sampling rate required for accurate compensation of out-of-band distortions is thus very high, and has a direct impact on power consumption and implementation complexity of DPD identification algorithms on digital processor. In this paper, we propose a new iterative DPD identification algorithm based on the Indirect Learning Architecture (ILA) and on subband decomposition of PA output signal. The proposed algorithm converges to conventional ILA solution with a drastic decrease in required sampling rate.

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to measure the parity - non - conservation coupling strength \(A_s\) between the Z boson and strange quarks. Specifically, the researchers hope to directly extract the value of this coupling parameter from experimental data to verify whether the Standard Model (SM) accurately predicts the interactions between different fermion types and the Z boson.

### Background Information

In weak interactions, the coupling between the Z boson and fermions (such as leptons, up quarks, and down quarks) exhibits significant parity - non - conservation characteristics. According to the Standard Model, under the Born approximation, the differential production cross - section can be expressed as:
\[ \sigma_f(x)=\frac{d\sigma_f}{dx}\propto(1 - A_eP_e)(1 + x^2)+2A_f(A_e - P_e)x \]
where \(x = \cos\theta\), \(\theta\) is the polar angle of the final - state fermion \(f\) relative to the electron - beam direction; \(P_e\) is the longitudinal polarization of the electron beam; the coupling parameter \(A_f=\frac{2v_fa_f}{v_f^2 + a_f^2}\) is defined as a function of the vector coupling \(v_f\) and the axial - vector coupling \(a_f\) between the Z boson and the fermion \(f\).

### Measurement Method

To measure \(A_s\), the researchers used the SLD experimental data from the SLAC linear collider. These data include approximately 550,000 hadronic decay events of the Z boson. The measurement was carried out through the following steps:

1. **Event Selection**: Use high - momentum \(K^{\pm}\) mesons, \(K_s\) mesons, or \(\Lambda^0/\bar{\Lambda}^0\) baryons to mark the hemisphere containing strange quarks.
2. **Background Suppression**: Use the vertex detector (VXD) to suppress heavy - flavor backgrounds (\(\bar{c}c\) and \(\bar{b}b\)) and require at least one high - momentum strange particle in each hemisphere.
3. **Polar - Angle Distribution Analysis**: Calculate the left - right - front - back asymmetry of the marked strange quarks in the polar angle and extract \(A_s\) from it.

The final result is:
\[ A_s = 0.85\pm0.06 (\text{stat.})\pm0.07 (\text{syst.}) \]

### Significance

This measurement result is consistent with the Standard Model's expectations and has higher precision than previous measurements. This helps to test the universality hypothesis of the coupling constants for leptons, up quarks, and down quarks in the Standard Model. In addition, this result can be compared with \(A_b\) measured in other experiments to further verify the correctness of the Standard Model.