Abstract:When applied in the hydrogen refueling station, the diaphragm compressor with super high pressure ratio will experience a high discharge temperature of over 200 degrees C, especially for that with large capacity and horsepower. Considering the thermal stress, the structural strength and deformation of the cylinder head are crucial to the reliability and efficiency of the diaphragm compressor. In this paper, a thermal-structural coupled analysis was proposed, based on which the deformation and stress of the diaphragm compressor cylinder head under high-temperature and high-pressure conditions were obtained. And the fatigue life of the studs on the cylinder head was also estimated based on the stress results obtained in the thermal-structural coupled analysis. The experimental method was conducted for verifying the numerical results. The results indicated that during the operation of the compressor, the temperature in the discharge holes was the highest, resulting in not only plastic deformation but also large stress concentration, and the high thermal stress could reach up to the strength limit of the material. A structural improvement was therefore proposed to decrease the stress in the region of the discharge holes by cutting a larger hole and attaching a new separate one for valve installation. Further stress analysis showed that the stress in the same region of the improved structure was significantly reduced, which guaranteed the safety of the compressor. (C) 2019 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

Analysis of Forming Factors for Build-Up Phenomenon in High Pressure Hydrogen Vessel

Stresses Controllable Analysis and Optimal Design of Unique High Pressure Vessel Applied in Hydrogen Charge Station

Mechanical Analysis of Carbon Fiber Filament Wound Hydrogen Storage Vessel with Aluminum Alloy Liner

Mechanical Analysis of Carbon Fiber Wound High Pressure Hydrogen Storage Vessel and Prestress Control in Manufacturing Process

DEVELOPMENT OF STRIP WINDING HIGH PRESSURE HYDROGEN STORAGE VESSEL WITH LOW STRESS INNER LINER

Structure design of mobile carbon fibre composite material high pressure hydrogen storage vessel

Mechanical Analysis and Optimal Design for Carbon Fiber Resin Composite Wound Hydrogen Storage Vessel With Aluminum Alloy Liner

Analysis of the Boss Structure of Type Ⅳ Composite Vessel for a High-Pressure Hydrogen Tube Trailer

Study on Burst Pressure of Type Ⅳ Hydrogen Storage Cylinder Based on Progressive Failure Analysis

Instability Analysis and Development of High Pressure Hydrogen Storage Vessels

Thermo-mechanical Investigation of Composite High-Pressure Hydrogen Storage Cylinder During Fast Filling

Design Fatigue Life Evaluation of High-Pressure Hydrogen Storage Vessels Based on Fracture Mechanics

Numerical Analysis of Temperature Rise Within 70 MPa Composite Hydrogen Vehicle Cylinder During Fast Refueling

Thermal-structural Coupled Analysis and Improvement of the Diaphragm Compressor Cylinder Head for a Hydrogen Refueling Station

Micromechanics-based Burst Failure Analysis of Composite Vessel Used for Hydrogen Storage

Design of Type-IV Composite Pressure Vessel Based on Comparative Analysis of Numerical Methods for Modeling Type-III Vessels

Elastic-Plastic Numerical Analysis of the Spinning Process of SA-372 Steel Used in High-Pressure Hydrogen Storage Cylinders (≥100 MPA)

Parametric analysis on multi-stage high pressure reducing valve for hydrogen decompression

Analysis of the Boss Structure of Type IV Composite Vessel for a High-Pressure Hydrogen Tube Trailer

Safety and Reliability Analysis of Multifunctional Layered High-pressure Hydrogen Storage Vessels

Numerical Study on Fast Filling of 70 MPa Type III Cylinder for Hydrogen Vehicle