Abstract:Waterborne thiol‐ene polymers, when combined with reduced graphene oxide platelets, offer a well‐balanced blend of amphiphilicity and resistivity. This combination enables the utilization of the composites in chemo‐resistive sensor applications for the selective detection of humidity within a concentration range of 800–5000 ppm. The response of these sensors is fast and reproducible. The current‐state of polymer‐based humidity sensors faces numerous limitations, including energy‐costly synthesis, low sensitivity, and slow response times. This study presents innovative approach to overcome these challenges, based on a robust all‐water‐borne in situ miniemulsion polymerization. The use of water throughout the entire process mitigates the negative environmental impact. Thiol‐ene polymers reinforced with reduced graphene oxide (rGO) with concentrations ranging from 0.2–1.0 wt% are selected to fabricate these chemoresistive sensors. The selected thiol‐enes present high hydrophobicity and a semicrystalline nature, suggesting resistance to early delamination even under prolonged exposure to humidity. Incorporating rGO not only imparts electrical conductivity but also enhances mechanical and water resistance of the composite films. The 0.6% rGO composite exhibits optimal resistance for humidity sensing, demonstrating rapid and consistent responses across three exposure cycles to water vapor concentrations ranging 800–5000 ppm. Moreover, the sensor exhibits remarkable selectivity toward water vapors over these of toluene, propanol, and 4‐methyl‐2‐pentanol, attributed to the high surface hydrophilicity and inherent porosity of the waterborne film, and network structuring of rGO platelets within the matrix. In summary, this study pioneers a novel approach to polymer‐based humidity sensing, addressing key limitations while offering enhanced sensitivity, rapid response times, and superior selectivity.

Galvinol as Ratiometric Naked-Eye Colorimetric Moisture Sensor: Synthesis Process Development, Applications and Mechanistic Studies

Detecting Moisture in Building Materials and Commercial Food adducts by 2-Hydroxy-naphthaldehyde Derived Chromo-Fluorogenic Chemosensor

Fluoride Induced Dual Mode Moisture Detection in Organic Solvents, Food, and Agricultural Materials using Benzothiazole Based Azo Dye Sensor

In Situ H2O Meter by Visualization in Hydrogels.

Colorimetric sensor arrays for molecular recognition

New Concept in Moisture detection with Unconventional pore morphology Design

Comprehensive Qualitative and Quantitative Colorimetric Sensing of Volatile Organic Compounds Using Monolayered Metal‐Organic Framework Films

VOC Sensing Using Batch-fabricated Temperature Compensated Self-Leveling Microstructures

Colorimetric Sensor Arrays for Volatile Organic Compounds

Metal-Organic Frameworks (MOFs)-Based Piezoelectric-Colorimetric Hybrid Sensor for Monitoring Green Leaf Volatiles

An ultrasound triggered gelation approach to selectively solvatochromic sensors

Bioinspired Hydrogel Interferometer for Adaptive Coloration and Chemical Sensing

Wettability gradient colorimetric sensing by amphiphilic molecular response.

Development of Polymer-based Chemical Sensor to Study the Impact of Polymer Concentration and Freeze-Thaw Cycle on the Detection of Gallic Acid

Colorimetry-based System for Gaseous Carbon Dioxide Detection

Detection of moisture in DMSO and raw food products by using an anthracene-based fluorescence OFF-ON chemosensor

Aggregation induced bathochromic shift of emission for detection of moisture in organic solvents and food stuffs

Cyclodextrin-Assisted Two-Component Sonogel for Visual Humidity Sensing

Advanced Nanostructured All‐Waterborne Thiol‐Ene/Reduced Graphene Oxide Humidity Sensors with Outstanding Selectivity

Fluorescent and ratiometric humidity sensor based on cyano-substituted oligo( p -phenylene)/silica gel hybrid materials

A Reversible Mechanochromic AIEgen Based on Triphenylamine for the Selective Detection of Vitamin B2 (Riboflavin) in Aqueous Media and Histotoxicity