Macroscopic Equations of Motion for Two Phase Flow in Porous Media

R. Hilfer

DOI: https://doi.org/10.1103/PhysRevE.58.2090

1998-04-28

Abstract:The established macroscopic equations of motion for two phase immiscible displacement in porous media are known to be physically incomplete because they do not contain the surface tension and surface areas governing capillary phenomena. Therefore a more general system of macroscopic equations is derived here which incorporates the spatiotemporal variation of interfacial energies. These equations are based on the theory of mixtures in macroscopic continuum mechanics. They include wetting phenomena through surface tensions instead of the traditional use of capillary pressure functions. Relative permeabilities can be identified in this approach which exhibit a complex dependence on the state variables. A capillary pressure function can be identified in equilibrium which shows the qualitative saturation dependence known from experiment. In addition the new equations allow to describe the spatiotemporal changes of residual saturations during immiscible displacement.

Materials Science

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the physical incompleteness of existing macroscopic equations in describing the flow of two - phase immiscible fluids in porous media. Specifically, traditional models fail to include surface tension and surface area that affect capillarity. Therefore, the author has derived a more general set of macroscopic equations of motion, which take into account the temporal and spatial variations of interface energy and are based on the theory of macroscopic continuum mechanics.

### Specific manifestations of the problem

1. **Limitations of traditional equations**:
- Traditional equations only include mass conservation and momentum conservation, but do not involve energy conservation.
- Surface tension and interface area are not incorporated into the model, resulting in an inability to accurately describe capillarity.
- Relative permeability and capillary pressure functions depend on saturation, while ignoring the influence of other state variables.

2. **Experimental observations inconsistent with theory**:
- Experiments show that residual saturation (such as immobile oil droplets) varies with time and space, while traditional models assume these parameters to be constant.
- Capillary pressure and relative permeability actually depend on flow rate and pressure, rather than just on saturation.

### Solutions

The author proposes a new system of macroscopic equations, with the following main improvements:

1. **Introduction of interface energy**:
- The new equations take interface energy into account, so that macroscopic state variables include not only saturation, pressure and velocity, but also interface area per unit volume.

2. **Extension of conservation laws**:
- The conservation laws of mass, momentum and energy are extended to include the change of interface energy.
- The concepts of percolating phase and trapped phase are introduced to better describe the dynamic behavior of residual saturation.

3. **Improvement of relative permeability and capillary pressure**:
- Relative permeability depends not only on saturation, but also on other macroscopic state variables, such as interface area and wetting characteristics.
- Capillary pressure exhibits the correct qualitative behavior under static conditions and can also reflect the actual spatio - temporal changes under dynamic conditions.

Through these improvements, the new model can more accurately describe the complex flow behavior of two - phase immiscible fluids in porous media, especially in the application of laboratory systems.