Abstract:Lithium sources are of great significance for developing the next generation of lithium ion batteries. Most of the world’s lithium sources are found in salt lake brines. The main challenge of lithium extraction from salt lake brine is the separation of lithium ions from other coexisting ions, especially the separation of Li + and Mg 2+ . However, the traditional precipitation method for salt lake lithium extraction is cumbersome. In this project, a new electrolytic device with a solid-state electrolyte was developed for high-efficient lithium extraction from salt lake brines. Li 1+x Al x Ti 2−x (PO 4 ) 3 (LATP) is a promising NASICON-type solid-state electrolyte, which exhibits high ionic conductivity ( >10 -4 S/cm) at room temperature. LATP can be used as a lithium ion conductor, that is only lithium ions can transfer through it, which is ideal for separating lithium ions from other ions in salt lake brines. In this project, high-quality LATP was fabricated at a low cost. An electrolytic device was developed for lithium extraction, in which LATP was used together with a sacrificial anode, molten salts, and an inert cathode. Salt lake brines need to be concentrated by solar and/or wind evaporation before lithium extraction. The electrolytic device was operated above the melting point of the concentrated brine water, at which LATP exhibits a higher ionic conductivity for fast lithium ion transfer. A tiny voltage was applied across the two electrodes to drive the electrochemical reaction. The composition of lithium sources before and after extraction was investigated by inductively coupled plasma-optical emission spectroscopy (ICP-OES). Results show that lithium sources with a higher purity level were successfully extracted with high efficiency. Impurity ions were almost completely blocked by LATP.

Continuous ion separation via electrokinetic-driven ion migration path differentiation: practical application to lithium extraction from brines

Numerical Simulation of Continuous Extraction of Li+ from High Mg2+/Li+ Ratio Brines Based on Free Flow Ion Concentration Polarization Microfluidic System

Continuous Flow‐By Electrochemical Reactor Design for Direct Lithium Extraction from Brines

Ion-"distillation" for isolating lithium from lake brine

Numerical simulation of Lithium extraction from salt Lake brines through force environment modulation in microfluidic channels with ion concentration polarization

Solar-driven membrane separation for direct lithium extraction from artificial salt-lake brine

Solid-State Electrolyte for Lithium Extraction from Salt Lake Brines

A Bioinspired Membrane with Ultrahigh Li+/Na+ and Li+/K+ Separations Enables Direct Lithium Extraction from Brine

Recovery of lithium from salt lake brine with high Na/Li ratio using solvent extraction

Three-chamber electrochemical reactor for selective lithium extraction from brine.

Fine-Tuning 2D Heterogeneous Channels for Charge-Lock Enhanced Lithium Separation from Brine

Lithium extraction from brine through a decoupled and membrane-free electrochemical cell design

Modeling and application of continuous ion exchanges process for lithium recovery from salt lake brine

Extraction of lithium from Chinese salt-lake brines by membranes: Design and practice

Selective recovery of lithium ion from its mixed solution with potassium and sodium by electrobaromembrane method

Ultrasound assisted efficient separation of lithium from brine with a composite polyether sulfone-ionic liquid membrane

Pulsed electric field controlled lithium extraction process by LMO/MXene composite electrode from brines

Electrochemical lithium extraction with continuous flow electrodes

Bipolar membrane capacitive deionization for the selective capture of lithium ions from brines and conversion to lithium hydroxide

Advances and promotion strategies of membrane-based methods for extracting lithium from brine

Continuous lithium extraction from brine by efficient redox-couple electrodialysis