Abstract:Statistical Process Control (SPC) charts are frequently used in the semiconductor manufacturing environment to monitor process quality and detect special-cause variations, hence, to take corrective actions when necessary. The important aspects of control charts to consider on production floors are identifying the primary objective of implementing control charts, the type of data to monitor and the most appropriate control limits to establish. When the quality data is a type of attribute data like the proportion of defectives from a production lot, a p-chart approach is most suitable. In p-chart applications, although the assumption of normally distributed process data is not mandatory, the widespread practice is to assume the normal distribution of process data when establishing the control limits. Yet again, the reality of industrial settings is that process data are most likely influenced by outliers, resulting in highly skewed distributions. This paper addresses these issues by proposing robust SPC charting techniques to detect special-cause variations in the semiconductor manufacturing processes. Here, we present a case study of a semiconductor company in Malaysia, Dominant Opto Technologies Sdn. Bhd. to propose three robust statistical approaches for monitoring the proportion of defectives in production lots. We apply M-estimates, median, and interquartile range to calculate the upper control limits (UCL) and found that robust estimators are more effective in detecting early process deterioration and capturing the out-of-control (OOC) conditions better than traditional control charts. By proposing robust methods, this study enlightens the practical aspects of process quality improvement for real-life manufacturing setups. Because a high OOC rate may impact manufacturing productivity, we recommend the decision-makers choose the types of control charts based on the implications of each robust approach toward quality and productivity. The significance of this study includes providing insights into setting up the appropriate attribute control charts for detecting defective proportions for professionals and SPC researchers working in these areas.

Controlling the Manufacture of Parts on Order and for Stock by the Gantt Progress Chart

Synchronized production planning method for assemble to order products of mass customization

A progressive mean control chart for monitoring time between events

Application of Asymmetric Geometric Charts for High Quality Process

The Economically Designed Control Chart for Short-Run Production Based on Bayesian Method

An improved multiple quality characteristic analysis chart for simultaneous monitoring of process mean and variance of steering knuckle pin for green manufacturing

On the Performance of Two-sided Control Charts for Short Production Runs.

Chart Allocation Strategy For Serial-Parallel Multistage Manufacturing Processes With Multiple Faults

Group-based Production Scheduling for Make-to-order Production

An Integrated Optimization Model Of Control Chart And Preventive Maintenance Policies For Non-Normal Data

Controlling Project Schedule Progress, Using Control Charts

Two-Level Nested Control Chart for Batch Process in the Semiconductor Manufacturing

Economic Design of VSI Control Chart for Short-Run Production

A proposed variable parameter control chart for monitoring the multivariate coefficient of variation

A broader view of the economic design of the X-bar chart in the semiconductor industry

Economic design of integrated model of control chart and maintenance management

An Arl-Unbiased Design Of Gamma Control Chart

A Combinned Control Chart to Monitor Small Process Mean

Robust Control Chart Application in Semiconductor Manufacturing Process

One-sided Shewhart control charts for monitoring the ratio of two normal variables in short production runs

A Progressive Approach for the Detection of the Coefficient of Variation