Deuterium Enrichment by PEM Water Electrolysis Using Water Circulation

Ibuki Sato,Hisayoshi Matsushima,Mikito Ueda

DOI: https://doi.org/10.1149/ma2023-02663199mtgabs

2023-12-22

ECS Meeting Abstracts

Abstract:Artemis Project, an international space exploration project proposed by the United States and involving Japan, plans a long-term manned lunar exploration in the late 2020s. That project considers the capture of He 3 , a resource for fusion that does not exist on Earth. On the other hand, He 3 is produced by the half-life of tritium (T). Now new hydrogen isotope separation is required for recovering T exhausted from nuclear reactors. The water electrolysis is well known to enrich protium (H) in gas phase and, deuterium (D) and T in the electrolyte [1]. The modern electrolysis is performed by solid polymer membrane water electrolysis (PEMWE). However, there are few reported cases for the isotope separation by PEMWE. In this study for pursing high D separation, the optimization of the electrolysis system was investigated. The initial D concentrations in the electrolyte were 10, 30, and 50 at% IrO 2 was used as the anode catalyst and Pt/C as the cathode one. The electrolysis was galvanostatically conducted. Hydrogen gas was analyzed by a quadrupole mass spectrometer (Q-Mass) to determine the ratio of H 2 , HD, and D 2 . The electrolyte was analyzed by Fourier transform infrared spectrophotometer (FT-IR) to determine the ratio of H 2 O, HDO, and D 2 O. Figure. 1 shows the schematic illustration of gas and water flow chart in experimental setup. Electrolyte was sent to the cell by the electric pump constantly. When the experiment was carried out, evolved gas and drained water was analyzed. The water out from the cell was returned into the electrolyte tank and electrolyzed repeatedly. The gas was introduced to Q-Mass. By using this circulation system, D was concentrated in the electrolyte efficiently . In this experiment, its concentration reached about 95at.%. To quantitatively evaluate the D enrichment by PEMWE, the separation factor α was calculated from the ratio of D concentrations in the electrolyte to the gas. The value of α was approximately 4.0. However, the valueslightly decreased above 90 at.% D. More detailed results will also be presented in our Poster, Abstract #176411. Figure 1