Laser‐Induced Solid‐Phase Strategy to Synthesize Single‐Atomic Lithiophilic Sites Enabled Dendrite‐Free Lithium Deposition on Graphene Matrix

ShuaiYu Gao,Lin Li,Yingbin Wu,Chunlan Lu
DOI: https://doi.org/10.1002/smtd.202400503
IF: 12.4
2024-10-03
Small Methods
Abstract:The Bi@LrGO material is synthesized through a laser‐induced solid‐phase method. During the pre‐lithiation process, Bi SA metal is loaded on the graphene not only provides sufficient lithiophilic sites but also significantly increases the adsorption energy with lithium atoms, which can significantly reduce the nucleation site of Li, making Bi@LrGO an effective lithium matrix, thereby facilitating the uniform plating/stripping of lithium. The introduction of metal Single‐atom (SA) to construct lithium‐philic active sites shows the ability to guide uniform lithium deposition and improve the stability of lithium hosts. Nevertheless, the development of facile and expedient methods for synthesizing SA remains a considerable challenge. Herein, The SA metal loaded on graphene (Bi@LrGO) is designed by laser‐induced solid‐phase strategy. The bismuth salts simultaneously decompose under the high local temperature and in the reductive atmosphere induced by laser to form SA metal. Simultaneously, graphene oxide (GO) nanosheets absorb photon energy to be reduced/graphitized into graphene, which serves as anchoring sites for Bismuth Sing‐atom (Bi SA) immobilization. The SA metals, supported on the graphene not only provide sufficient lithiophilic sites but also significantly increase the adsorption energy (−2.11 eV) with lithium atoms, promote the uniform nucleation and deposition of lithium, and inhibit the growth of lithium dendrites. Additionally, the layered structure of the graphene film adapts to the volume change during the repeated lithium plating/stripping process. Therefore, the symmetrical battery‐based Li deposited on Bi@LrGO (Bi@LrGO@Li) achieves an ultra‐long stable cycle life of ≈2400 h at 1 mA cm−2. In particular, a full cell with LiFePO4 cathode provides a good capacity retention of 81.2% at 4 C after 600 cycles.
materials science, multidisciplinary,chemistry, physical,nanoscience & nanotechnology
What problem does this paper attempt to address?