Abstract:The new Laser Ranging Interferometer (LRI) on GRACE Follow-On is measuring, just like the microwave instrument (MWI), the distance variations between the two satellites, but with a significantly higher precision. The Albert Einstein Institute (AEI) in Hannover was involved in the development of the LRI and is currently concerned with instrument operation and data analysis. &#160;In order to verify and validate the correctness of the Science Data System (SDS) derived LRI1B data product, currently available as release 04, we started to implement an own processing chain to convert data from raw level0 or level 1A to level1B, where the latter is usually employed in gravity field recovery. Besides the validation, we are interested in testing alternative processing strategies, which could improve the data quality and that might get adopted by official processing centers at some point. We will provide an overview on our processing strategy, which includes five major steps 1) Deglitching of the piston phase in order to remove phase jumps that occur when the attitude control thrusters are activated. 2) Conversion of time-tags from LRI time to GPS time and forming the phase difference of master and transponder measurements. &#160;This removes the common 10 MHz ramp in the measurements. 3) Conversion of the phase to a physical length, the non-instantaneous biased range 4) Filtering and down-sampling of the data to the LRI1B rate of 0.5 Hz. &#160;5) Finally, the light time correction (LTC) is calculated and allows to transform the non-instantaneous biased range and its derivatives to the instantaneous or corrected biased range. We will highlight the main differences in our processing to the RL04 processing, as far as known to us. In the end, we compare the RL04 and our data set at the 1B level, which shows a slightly lower noise and uses less empirical parameters.

Analysis of GRACE Follow-On Laser Ranging Interferometer Derived Inter-Satellite Pointing Angles

What Can be Expected from the GRACE-FO Laser Ranging Interferometer for Earth Science Applications?

Residual Patterns in GRACE Follow-On Laser Ranging Interferometry Post-Fit Range Rate Residuals

Flight phasemeter on the Laser Ranging Interferometer on the GRACE Follow-On mission

Disturbances from Single Event Upsets in the GRACE Follow-On Laser Ranging Interferometer

On orbit performance of the GRACE Follow-On Laser Ranging Interferometer

General relativistic laser interferometric observables of the GRACE-Follow-On mission

Comparing GRACE-FO KBR and LRI ranging data with focus on carrier frequency variations

An alternative derivation of the GRACE Follow-On LRI1B product: current status

Pointing and tracking errors due to low-frequency deformation in inter-satellite laser communication

Bridging the gap between GRACE and GRACE Follow-On by combining high–low satellite-to-satellite tracking data and satellite laser ranging

On-axis Optical Bench for Laser Ranging Instruments in future gravity missions

The impact of new accelerometer transplant data (ACH) on GRACE Follow‐On along‐orbit inter‐satellite laser ranging observations and monthly time‐variable gravity and mascon solutions

Analysis of attitude errors in GRACE range-rate residuals - a comparison between SCA1B and the reprocessed attitude fused product (SCA1B +ACC1B)

A hybrid approach for recovering high-resolution temporal gravity fields from satellite laser ranging

A Simplified Gravitational Reference Sensor for Satellite Geodesy

Model on picometer-level light gravitational delay in the GRACE Follow-On-Like missions

Laboratory demonstration of an off-axis optical bench design for future gravity missions

Tilt-to-Length Coupling Analysis of an Off-Axis Optical Bench Design for NGGM

Lunar laser ranging: The pointing error analysis to Lunokhod 1 and Lunokhod 2