Abstract:This paper provides a comparative study of the performance of cross-flow and counter-flow M-cycle heat exchangers for dew point cooling. It is recognised that evaporative cooling systems offer a low energy alternative to conventional air conditioning units. Recently emerged dew point cooling, as the renovated evaporative cooling configuration, is claimed to have much higher cooling output over the conventional evaporative modes owing to use of the M-cycle heat exchangers. Cross-flow and counter-flow heat exchangers, as the available structures for M-cycle dew point cooling processing, were theoretically and experimentally investigated to identify the difference in cooling effectiveness of both under the parallel structural/operational conditions, optimise the geometrical sizes of the exchangers and suggest their favourite operational conditions. Through development of a dedicated computer model and case-by-case experimental testing and validation, a parametric study of the cooling performance of the counter-flow and cross-flow heat exchangers was carried out. The results showed the counter-flow exchanger offered greater (around 20% higher) cooling capacity, as well as greater (15%–23% higher) dew-point and wet-bulb effectiveness when equal in physical size and under the same operating conditions. The cross-flow system, however, had a greater (10% higher) Energy Efficiency (COP). As the increased cooling effectiveness will lead to reduced air volume flow rate, smaller system size and lower cost, whilst the size and cost are the inherent barriers for use of dew point cooling as the alternation of the conventional cooling systems, the counter-flow system is considered to offer practical advantages over the cross-flow system that would aid the uptake of this low energy cooling alternative. In line with increased global demand for energy in cooling of building, largely by economic booming of emerging developing nations and recognised global warming, the research results will be of significant importance in terms of promoting deployment of the low energy dew point cooling system, helping reduction of energy use in cooling of buildings and cut of the associated carbon emission.

Performance study of the Maisotsenko Cycle heat exchangers in different air-conditioning applications

Numerical Study of Heat and Mass Transfer Process in the Maisotsenko Cycle for Indirect Evaporative Air Cooling

Numerical analysis of selected evaporative exchangers with the Maisotsenko cycle

Numerical study of the Maisotsenko cycle heat and mass exchanger

Performance investigation of a M (Maisotsenko)-cycle cross-flow heat exchanger used for indirect evaporative cooling

Application of the cross-flow Maisotsenko cycle heat and mass exchanger to the moderate climate in different configurations in air-conditioning systems

Performance study of the cross-flow Maisotsenko cycle in humid climate conditions

THE ENERGY AND EXERGY ANALYSIS ON THE PERFORMANCE OF COUNTER-FLOW HEAT AND MASS EXCHANGER FOR M-CYCLE INDIRECT EVAPORATIVE COOLING

Simulation, Experimentation, and Collaborative Analysis of Adjacent Heat Exchange Modules in a Vehicular Cooling System

Numerical study and optimization of the cross-flow Maisotsenko cycle indirect evaporative air cooler

Analysis of different applications of Maisotsenko cycle heat exchanger in the desiccant air conditioning systems

A comprehensive review of the Maisotsenko-cycle based air conditioning systems

Maisotsenko cycle: technology overview and energy-saving potential in cooling systems

Thermodynamic performance assessment of a novel air cooling cycle: Maisotsenko cycle

Numerical Study of a M-cycle Cross-Flow Heat Exchanger for Indirect Evaporative Cooling

Experimental analysis of an improved Maisotsenko cycle design under low velocity conditions

The Maisotsenko Cycle for Electronics Cooling

Two-dimensional Numerical Study of a Heat and Mass Exchanger for a Dew-Point Evaporative Cooler

Modeling of a Condenser in Dynamic Operation Using Comsol Multiphysics Software

Performance Analysis of a Hollow Fiber Membrane-Based Heat and Mass Exchanger for Evaporative Cooling

Performance Evaluation of a Direct Evaporative Cooling System with Hollow Fiber-Based Heat Exchanger