Abstract:Ammonia (NH3) is emerging as a promising alternative fuel for longer range decarbonised heavy transport, particularly in the marine sector due to highly favourable characteristics as an effective hydrogen carrier. This is despite generally unfavourable combustion and toxicity attributes, restricting end use to applications where robust health and safety protocols can be upheld. In the currently reported work, a spark ignited thermodynamic single cylinder research engine equipped with gasoline direct injection was upgraded to include gaseous ammonia port injection fuelling, with the aim of understanding maximum viable ammonia substitution ratios across the speed-load operating map. The work was conducted under overall stoichiometric conditions with the spark timing re-optimised for maximum brake torque at all stable logged sites. The experiments included industry standard measurements of combustion, performance and engine-out emissions (including NH3 “slip”). With a geometric compression ratio of 12.4:1, it was possible to run the engine on pure ammonia at low engine speeds (1000-1800rpm) at low-to-moderate engine loads in a fully warmed up state. When progressively dropping down below a threshold load limit, an increasing amount of gasoline co-firing was required to avoid engine misfire. Due to the favourable anti-knock characteristics, pure ammonia operation was up to 5% more efficient than pure gasoline operation under stable operating regions. A maximum net indicated thermal efficiency of 40% was achieved, with efficiency tending to increase with speed and load. For the co-fuelling of gasoline and ammonia in a pure ammonia attainable operating region, it was found that addition of gasoline improved the combustion, but these improvements were not sufficient to translate into improved thermal efficiency. Emissions of NH3 slip reduced with increased gasoline co-fuelling, albeit with increased NOx. However, the reduction in NH3 slip was nearly 10 times the increase in NOx emissions. Comparing pure NH3 and pure gasoline operation, NOx reduced by ~60% when switching from pure gasoline to pure NH3 (as the latter is associated with longer and cooler combustion). Results were finally compared to those obtained a modern multi-cylinder Volvo “D8” turbo-diesel engine modified for dual fuel operation with ammonia port fuel injection, with the focus of the comparison being NH3 slip and NOx emissions.

Comparative analysis of ammonia and hydrogen fuel blends in diesel engines on performance, emission, vibration, and acoustic profiles

Investigation on Thermal Properties of a Novel Fuel Blend and Its Diesel Engine Performance

Ammonia-enriched biogas as an alternative fuel in diesel engines: Combustion, performance and emission analysis

Hydrogen Enriched Ammonia Engines: Assessment of Hydrogen Concentration in the Fuel Feed from the Laminar Flame Speed Viewpoint

Hydrogen and ammonia as a primary fuel – A critical review of production technologies, diesel engine applications, and challenges

Numerical investigation of the hydrogen, ammonia and methane fuel blends on the combustion emissions and performance

Carbon neutrality with ammonia: An analysis of its feasibility as a fuel for diesel engines fuelled with spirulina microalgae and oxygenated additives

The impact of ammonia and hydrogen additives on the combustion characteristics, performance, stability and emissions of an industrial DF diesel engine

Mechanical engineering advantages of a dual fuel diesel engine powered by diesel and aqueous ammonia blends

Computational Analysis of Ammonia-Hydrogen Blends in Homogeneous Charge Compression Ignition Mode of Engine Operation

Numerical study on the use of ammonia/hydrogen fuel blends for automotive spark-ignition engines

Effects of nano-additives and ammonia on performance and emission characteristics of diesel engine fueled with Aleurites moluccanus

Experimental and numerical analysis of engine characteristics of an ammonia-substituted dual-fuel CRDI diesel engine

Simulation Study on Combustion Performance of Ammonia-Hydrogen Fuel Engines

Effects of using ammonia as a primary fuel on engine performance and emissions in an ammonia/biodiesel dual‐fuel CI engine

Evaluation of Ammonia Co-fuelling in Modern Four Stroke Engines

Effect of Burning Ammonia/Hydrogen Blended Fuel on Engine Combustion and Emission Performance

Effect of ammonia/hydrogen blending and injection modes on combustion emission and performance of marine engine

Study on the Impact of Ammonia–Diesel Dual-Fuel Combustion on Performance of a Medium-Speed Diesel Engine

Enhancing sustainable fuel solutions: Castor oil biodiesel with nanoparticles and ammonia, utilizing as a green substitute for diesel engines

Evaluation of ammonia-gasoline co-combustion in a modern spark ignition research engine