Effect of Cd2+ on the red emission of Mn2+-doped zinc phosphoborate glasses

Changyuan Xu,Hongming Yin,Wenqiang Song,Qun Wang,Fengjiao Zhao
DOI: https://doi.org/10.1007/s10854-024-12904-x
2024-06-15
Journal of Materials Science Materials in Electronics
Abstract:When employing the conventional melt quenching technique for the preparation of Mn 2+ -doped glasses, it is observed that Mn 2+ readily undergoes oxidation to Mn 3+ during high-temperature melting. Typically, researchers incorporate reducing agents into the synthesized raw materials or utilize a reducing atmosphere when preparing samples to mitigate this phenomenon. In this study, a novel approach was proposed to suppress Mn 2+ oxidation and enhance its luminescent properties. The zinc phosphoborate glasses based on 28.1P 2 O 5 –10.9B 2 O 3 –28.1ZnO (P–B–Zn) were prepared using the traditional melt quenching method. The effect of Cd 2+ on the red emission of Mn 2+ was studied by doping 2.9 mol% Mn 2+ and changing the concentration of Cd 2+ in the glasses. The analysis of photoluminescence emission (PL) spectroscopy and photoluminescence excitation (PLE) spectroscopy revealed a significant enhancement in the red emission resulting from the 4 T 1 (G) → 6 A 1 (S) transition of Mn 2+ under 409 nm excitation after doping with Cd 2+ ions. When the doping content of Cd 2+ is 19 mol%, the luminescence intensity of Mn 2+ reaches its maximum value, which is 4.24 times higher than that of undoped Cd 2+ . The results of the absorption and transmission spectra indicate a weakening of the 5 E g → 5 T 2g transition of Mn 3+ and an increase in the transparency of the glasses. The significant reduction in the absorption peak of Mn 3+ suggests that doping Cd 2+ can effectively inhibit the oxidation of Mn 2+ to Mn 3+ , as further confirmed by X-ray photoelectron spectroscopy (XPS) analysis.
materials science, multidisciplinary,engineering, electrical & electronic,physics, applied, condensed matter
What problem does this paper attempt to address?