Sharp Bounds for Eigenvalues and Multiplicities on Surfaces of Revolution

Martin Engman
DOI: https://doi.org/10.48550/arXiv.dg-ga/9604003
1996-04-13
Abstract:We find sharp upper bounds for the multiplicities and the numerical values of all the distinct eigenvalues on a surface of revolution diffeomorphic to the sphere.
Differential Geometry
What problem does this paper attempt to address?
This paper attempts to solve the problem of designing a muon - antimuon collider storage ring with a high - luminosity 4 TeV center - of - mass energy. Specifically, the authors explore how to achieve the following goals: 1. **Extremely low β value**: In order to reach the designed luminosity \( L = 10^{35} \, \text{cm}^{-2}\text{s}^{-1} \), an extremely low β value \( \beta^* = 3 \, \text{mm} \) needs to be achieved at the interaction point (IP). 2. **Dispersion correction**: Since the β - function is about 400 kilometers in the final - focusing quadrupole magnets, a sextupole - magnet scheme is required for local dispersion correction to counteract the corresponding dispersion effects. 3. **Beam - length control**: The hourglass effect limits the beam length to be comparable to the β value. To obtain such a short beam and maintain a reasonable radio - frequency voltage, a very small momentum - compression factor α is required. 4. **Quasi - isochronous design**: In order to achieve a very short 3 - millimeter beam, the storage ring must be quasi - isochronous, that is, the momentum - compression factor α is very close to zero. 5. **Suppression of the expansion of the momentum - compression factor**: Although the design has been adjusted for the isochronism of the reference particle, defocused particles will still see a small non - zero momentum - compression factor. Therefore, further optimization is required to reduce the range of variation of the momentum - compression factor. 6. **Dispersion - suppression module**: A dispersion - suppression module is set at the end of each arc section, so that the dispersion and its slope in the straight - line part of the adjacent insertion regions are zeroed. 7. **Design of experimental and utility insertion regions**: The experimental insertion region is used to achieve an interaction region with an extremely low β value, while the utility insertion region relaxes the focusing conditions to reduce the β - function value. Through these design and technical means, the authors hope to construct a feasible muon - collider storage ring and provide a basis for future detailed design studies.