Abstract:Magnesium (Mg) and graphene in alloy formulations are of paramount importance for lightweight engineering applications. In the present study, ZE10 Mg-alloy-based nanocomposites reinforced with graphene nanoplatelets (GNPs) having a thickness of 10–20 nm were fabricated via ultrasound-assisted stir casting. The effect of GNP contents (0.25, 0.5, and 1.0 wt.%) on the microstructure, Vickers hardness, and tensile properties of nanocomposites was investigated. Further, tribological studies were performed under a ball-on-disc sliding wear configuration against a bearing ball counterbody, at room and elevated temperatures of 100 °C and 200 °C, to comprehend temperature-induced wear mechanisms and friction evolution. It was revealed that the GNP addition resulted in grain coarsening and increased porosity rate of the Mg alloy. While the composites exhibited improved hardness by 20–35% at room temperature and 100 °C, a minor change was observed in their hardness and tensile yield strength values at 200 °C with respect to the GNP-free alloy. A notable improvement in lowering and stabilizing friction (coefficient of friction at 200 °C~0.25) and wear values was seen for the self-lubricating GNP-added composites at all sliding temperatures. The worn surface morphology indicated a simultaneous occurrence of abrasive and adhesive wear mode in all samples at room temperature and 100 °C, while delamination and smearing along with debris compaction (tribolayer protection) were the dominant mechanisms of wear at 200 °C. Inclusively, the results advocate steady frictional conditions, improved wear resistance, and favorable wear-protective mechanisms for the Mg alloy–GNP nanocomposites at room and elevated temperatures.

Effect of nano-graphene as an additive for the improved rolling contact fatigue life of through hardened AISI 4140 alloy steel

Rolling contact fatigue studies on AISI 4140 steel under formulated lubrication conditions with nano graphene additives

Impact of Graphene Nano-Additives to Lithium Grease on the Dynamic and Tribological Behavior of Rolling Bearings

The effect of retained austenite on rolling/sliding contact fatigue of high carbon steel

An Investigation on Tribological Properties of Graphite Nanosheets As Oil Additive

Microstructural-based analysis of the unexpected differences in rolling contact fatigue behavior between SAE52100 and SAE4320

Synergistic friction-reduction and wear-resistance mechanism of 3D graphene and SiO2 nanoblend at harsh friction interface

A Rolling Contact Fatigue Study of Hard Carbon Coated M-50 Steel

Effects of carburizing and nitriding sequential treatment on rolling contact fatigue of M50NiL bearing steel

Reduced friction and wear enabled by arc-discharge method-prepared 3D graphene as oil additive under variable loads and speeds

A study on the lubrication effects of nano‐TiO2 additive water‐based lubricants during rolling of ferritic stainless steel strips

Effect of Graphene-Based Nanoadditives on the Tribological and Rheological Performance of Paraffin Grease

Finite Element Analysis Simulation of the Effect of Induction Hardening on Rolling Contact Fatigue

Tribological evaluation of steel–steel contact surface lubricated by graphene nanoparticle-enhanced lubricant

Effect of Graphene Addition to Lithium-Based Grease on the Performance of Rolling Element Bearings

Combining Carbon Nanoparticle Coatings and Laser Surface Texturing for Enhanced Lubricity Under High Loads

Nano and micro structures produced from carbon rich fly ash as effective lubricant additives for 150SN base oil

Tribological properties of nano-graphite as an additive in mixed oil-based titanium complex grease

Effect of Graphene Nanoplatelet Content on Mechanical and Elevated-Temperature Tribological Performance of Self-Lubricating ZE10 Magnesium Alloy Nanocomposites