GAS DISPERSION AND SOLID SUSPENSION IN A THREE-PHASE STIRRED TANK WITH MULTIPLE IMPELLERS
Yuyun Bao,Zhigang Hao,Zhengming Gao,Litian Shi,John M. Smith,Rex B. Thorpe
DOI: https://doi.org/10.1080/00986440500267261
2006-07-01
Chemical Engineering Communications
Abstract:Despite much research on gas-liquid-solid systems and their widespread application in industry, gas dispersion with solid suspension in multistage stirred reactors equipped with multiple impellers has received little attention. We report here the critical just-suspension impeller speed for different concentrations of solid particles, gas holdup, and shaft power in a vessel of 0.48 m diameter with four baffles and dished base. Five agitator configurations, each with three impellers mounted on a single shaft, have been used in the experiments. Two novel impeller designs were used, a deep hollow blade (semi-ellipse) disc turbine (HEDT) and four-wide-blade hydrofoil impellers. The hydrofoils were used in both up-pumping (WHU) and down-pumping (WHD) modes. Glass beads of 50 ∼ 150 μm diameter and density 2500 kg · m−3 were suspended at solid volumetric concentrations of 1.5, 3, 6, 9, and 15%. Results show that these suspended solids have little effect on the relative power demand. Agitators using the HEDT radial dispersing impeller at the bottom have a higher relative power demand (RPD = PG/PU) than those with WHD or WHU as the lowest one. For all impeller combinations there is little or no effect on gas holdup with increasing solid concentrations. Of the five different impeller combinations, those with an axial flow bottom impeller have significantly higher just-suspension agitation speeds and power consumption, so mounting the hydrofoil impeller at the bottom is not the optimal configuration for particle suspension. Of these impeller combinations, at a given gas flow rate the arrangement of HEDT + 2WHU has the highest relative power demand, gas holdup, and power input for both the suspension of settling particles and gas dispersion.
engineering, chemical