Abstract:X-ray irradiation on dielectric materials will affect their electrical properties, reducing the service life of the equipment. Therefore, calculating and measuring the radiation-induced conductivity is of tremendous significance in studying the radiation effects of dielectric materials. For the research requirements of detector calibration and numerical calculation of radiation-induced conductivity, the generation method of quasi-monochromatic X-ray is studied. The geometric model is established, and the Monte Carlo numerical simulations of the emitted energy spectrum and the photon numbers are carried out. A steady-state quasi-monochromatic X-ray conductivity measurement system was built to test polyimide materials. Experiments show that under a strong electric field and quasi-monochromatic X-ray, the volume conductivity of the sample can rise to 10−16– $10^{-15}\,\,\Omega ^{-1} \cdot \text { cm}^{-1}$ . The radiation-induced conductivity is in the order of $10^{-16}\,\,\Omega ^{-1} \cdot \text { cm}^{-1}$ and increases with the X-ray intensity. The Rose-Fowler-Vaisberg (RFV) model is discretized for MATLAB numerical calculation. The radiation-induced conductivity of polyimide material is calculated based on the model under specified X-ray energy and X-ray tube current. The calculated results are consistent with the experimental results using the given parameters. The radiation-induced conductivity increases linearly with the increase of X-ray intensity.

Electromagnetic emission of integrated circuits induced by ionizing radiation and its measurement uncertainties

Equivalent Radiation Source of 3D Package for Electromagnetic Characteristics Analysis

An Effective Equivalent Radiation Source Based on Near-field Scanning for Electromagnetic Interference Estimation

An EM Imaging Method Based on Plane-Wave Spectrum and Transmission Line Model

Overview of radiation hardening techniques for IC design

Radiated Emissions Prediction of an Electronic Packaging Based on Near-field Scanning

Modeling the effects of low-LET cosmic rays on electronic components

Electromagnetic Sensitivity Analysis of Radio Frequency Front-End Module in Wireless Intelligent Sensors Subjected to Nanosecond Electromagnetic Pulse

Ensuring the reliability of power electronic devices with regard to terrestrial cosmic radiation

Monte Carlo Numerical Simulation and Experimental Study of Polyimide under Monochromatic Steady-state X-Ray Radiation

Radiation Risks and Mitigation in Electronic Systems

Experimental research for γ-ray interference threshold of high electromagnetic pulse sensor

Measurement of swelling-induced residual stress in ion implanted SiC, and its effect on micromechanical properties

Radiation-Induced Conductivity of Polyimide under Monochromatic X-Ray Irradiation: Calculation, Numerical Simulation, and Measurement.

Total Ionizing Dose Effects on a Radiation-Hardened CMOS Image Sensor Demonstrator for ITER Remote Handling

Ionizing Radiation Testing System for Emerging Semiconductor Materials and Devices

Energy Dependence of Atmospheric Neutron-Induced Failures in Silicon Carbide Power Devices

Single-Event Effect Responses of CMOS Integrated Planar Multiturn Inductors in LC-Tank Oscillators Under Heavy-Ion Microbeam Irradiation

Measurement Methodology for Field-Coupled Soft Errors Induced by Electrostatic Discharge

Radiation Damage Induced by Various Particles on CC4013 Devices

Gamma Irradiation Induced Total Dose Effects of EE80C196KC20 Single Chip Microprocessor