Preparation and Properties of Copper(I) Complexes Based on 1,2-Bis(diphenylphosphine) Ethane

Dan Zheng,Qibang Tong

DOI: https://doi.org/10.1134/s0036024423130058

2023-12-01

Russian Journal of Physical Chemistry A

Abstract:Phosphorescent Cu(I) complexes have aroused wide attention over the past few years since they are environment-friendly and exhibit low cost, diverse structure, and high photon yield. This complex type has been extensively employed in several fields (e.g., optical probes, photocatalysis, organic luminescence devices, cell imaging, etc.). This paper investigated the photocatalytic degradation of the phosphorescent Cu(I) complex and its application as a phosphorescent probe. The specific methods are elucidated as follows: Phosphorescent Cu(I) complexes were prepared by solution method using 1,2-bis(diphenylphosphine) ethane (dppe), copper iodide, and 1,10-phenanthroline-5,6-diketone (phon) as raw materials, and with acetonitrile as solvent. Subsequently, the prepared complexes were characterized through IR, XRD, SEM, UV‒Vis, and fluorescence spectra. Moreover, dyeing wastewater was simulated with methyl orange as the object. The effects of the initial concentration of methyl orange, illumination time, phosphorescent Cu(I) complexes dosage, and temperature on photocatalytic degradation were studied using the single-factor method. The phosphorescent Cu(I) complex served as a phosphorescent probe for detecting and analyzing tetracycline hydrochloride, doxycycline hydrochloride, and chlortetracycline hydrochloride. As indicated by the experimental results, the synthesized phosphorescent Cu(I) complex exhibited an amorphous flake structure. The DMF solution of the synthesized material had an ultraviolet absorption peak of 272 nm and a fluorescence emission peak of 384 nm. The optimum initial methyl orange concentration was determined as 10 mg/L, the optimum illumination time was 180 min, the optimum phosphorescent Cu(I) material dosage was 25 mg, and the maximum degradation rate was determined as 43.5%. The detection limit of tetracycline hydrochloride, doxycycline hydrochloride, and chlortetracycline hydrochloride was 5 × 10–9 mol/L using phosphorescent Cu(I) complex as a phosphorescent probe.

chemistry, physical