Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

SciFi Front-End Electronics: calibration and results on detector performance

Calibration of Soft X-Ray Detection with Synchrotron Radiation

Applications for Synchrotron Radiation in Inertial Confinement Fusion Research

SciFi: A large Scintillating Fibre Tracker for LHCb

Architecture of the LHCb muon Frontend control system upgrade

The LHCb software and computing upgrade for Run 3: opportunities and challenges

Calibration and Performance of the Upgraded ALICE Inner Tracking System

The upgrade of the CMS electromagnetic calorimeter for HL-LHC

Development of a new Front End electronics in Silicon and Silicon-Germanium technology for the Resistive Plate Chamber detector for high rate experiments

On-beam system test of the new readout electronics for the CMS Electromagnetic Calorimeter upgrade

Physics program and performance of the ALICE Forward Calorimeter upgrade (FoCal)

Functional characterization of modules for the Silicon Tracking System of the CBM experiment

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

Performance of a Highly Granular Scintillator-SiPM Based Hadron Calorimeter Prototype in Strong Magnetic Fields

Selection and processing of calibration samples to measure the particle identification performance of the LHCb experiment in Run 2

Test and performance of the CMS ECAL barrel data conversion and digital processing ASIC for HL-LHC

Electronics design and testing of the CMS Fast Beam Condition Monitor for HL-LHC

Development of a modular and scalable data acquisition system for calorimeters at a linear collider

The LHCb upgrade I

Latest R\&D news and beam test performance of the highly granular SiW-ECAL technological prototype for the ILC

First Years of Running for the LHCb Calorimeter System