Abstract:Abstract Eradicating biofouling from implant surfaces is essential in treating peri-implant infections, as it directly addresses the microbial source for infection and inflammation around dental implants. This controlled laboratory study examines the effectiveness of the four commercially available debridement solutions (EDTA (Prefgel®), NaOCl (Perisolv®), H2O2 (Sigma-Aldrich), and Chlorhexidine (GUM® Paroex®)) in removing the acquired pellicle, preventing pellicle re-formation, and removing of a multi-species oral biofilm growing on a titanium implant surface, and compare the results with the effect of a novel formulation of a peroxide activated Poloxamer gel (Nubone® Clean). Evaluation of pellicle removal and re-formation was conducted using Scanning Electron Microscope (SEM), Energy Dispersive X-ray Spectroscopy (EDX), and X-ray photoelectron spectroscopy (XPS) to assess the surface morphology, elemental composition, and chemical surface composition. Hydrophilicity was assessed through contact angle measurements. The multi-species biofilm model included Streptococcus oralis, Fusobacterium nucleatum, and Aggregatibacter actinomycetemcomitans, reflecting the natural oral microbiome's complexity. Biofilm biomass was quantified using safranin staining, biofilm viability was evaluated using confocal laser scanning microscopy, and SEM was used for morphological analyses of the biofilm. Results indicated that while no single agent completely eradicated the biofilm, the Poloxamer gel activated with H2O2 exhibited promising results. It minimised re-contamination of the pellicle by significantly lowering the contact angle, indicating enhanced hydrophilicity. This combination also showed a notable reduction in carbon contaminants, suggesting the effective removal of organic residues from the titanium surface, in addition to effectively reducing viable bacterial counts. In conclusion, the Poloxamer gel + H2O2 combination emerged as a promising chemical decontamination strategy for peri-implant diseases. It underlines the importance of tailoring treatment methods to the unique microbial challenges in peri-implant diseases and the necessity of combining chemical decontaminating strategies with established mechanical cleaning procedures for optimal management of peri-implant diseases.

What problem does this paper attempt to address?

This paper attempts to solve the problem of biofouling on the surface of titanium implants, specifically for peri - implant infections. The main research objective of the paper is to evaluate the effects of several commercial decontamination solutions and a new type of peroxide - activated Poloxamer gel in removing the acquired pellicle, preventing the re - formation of the pellicle, and removing multi - species oral biofilms. Through these studies, the paper hopes to find an effective chemical decontamination strategy to deal with the biofouling problem on the surface of titanium implants. ### Specific problems and solutions 1. **Removal of the acquired pellicle**: - The acquired pellicle is the initial stage of biofilm formation, which provides a basis for bacterial attachment and subsequent biofilm maturation. Therefore, removing the pellicle is crucial for the prevention and treatment of biofilm - related diseases. 2. **Prevention of pellicle re - formation**: - Even if the pellicle is successfully removed, if its re - formation cannot be effectively prevented, the biofilm will still reappear. Therefore, the study also evaluated the ability of different decontaminants to prevent pellicle re - formation. 3. **Removal of multi - species oral biofilms**: - Multi - species oral biofilms are complex structures composed of multiple bacteria, such as Streptococcus oralis, Fusobacterium nucleatum, and Aggregatibacter actinomycetemcomitans, etc. These bacteria work together to cause inflammation and bone destruction around periodontal implants. Therefore, removing these biofilms is crucial for the treatment of peri - implant infections. ### The role of the new Poloxamer gel The paper paid special attention to a new type of peroxide - activated Poloxamer gel (Poloxamer gel + H₂O₂) and compared it with other common decontaminants. The results showed that: - **Removal of pellicle**: The new gel performed excellently in removing the pellicle, significantly reducing the contact angle and enhancing the surface hydrophilicity. - **Prevention of pellicle re - formation**: Compared with using only H₂O₂, this combination significantly reduced the re - formation of the pellicle. - **Removal of biofilms**: This combination also had a relatively significant effect on the removal of multi - species oral biofilms, reducing the number of viable bacteria and effectively removing organic residues. ### Conclusion The study concluded that the combination of Poloxamer gel and peroxide is a promising chemical decontamination strategy that can effectively meet the microbial challenges in periodontal implant diseases. In addition, the study emphasized the importance of tailoring treatment methods according to the specific microbial environment and pointed out that combining chemical decontamination methods with mechanical cleaning is the best solution for managing periodontal implant diseases. ### Formula display To ensure the correctness and readability of the formulas, the following are several key formulas involved in the paper: - Contact angle measurement: \[ \theta=\arccos\left(1 - \frac{2V}{\pi r^{2}h}\right) \] where \( V \) is the droplet volume, \( r \) is the droplet radius, and \( h \) is the droplet height. - Calculation of atomic percentage in XPS analysis: \[ \%C=\frac{N_C}{N_{total}}\times 100\% \] where \( N_C \) is the count of carbon elements and \( N_{total} \) is the total count of all elements. It is hoped that this information can help you better understand the research content and significance of this paper. If you have any further questions or need more detailed explanations, please feel free to let me know!

Biofouling on Titanium Implants: A Novel Formulation of Poloxamer and Peroxide for In situ Removal of Pellicle and Multispecies Oral Biofilm

Biological and Immunotoxicity Evaluation of Antimicrobial Peptide-Loaded Coatings Using a Layer-by-layer Process on Titanium

Electrochemical removal of peri-implantitis associated biofilms from titanium implant surfaces by in-situ anodization

Effect of implant cleaning on titanium particle dissolution and cytocompatibility

Effectivity of homecare and professional biofilm removal procedures on initial supragingival biofilm on laser-microtextured implant surfaces in an ex vivo model

Lysosome‐Inspired Enclosed and Deep Surface Decontamination Strategy for Management of Peri‐Implant Infections

Antimicrobial efficiency and cytocompatibility of resveratrol and naringin as chemical decontaminants on SLA surface

Efficiency of cold atmospheric plasma, cleaning powders and their combination for biofilm removal on two different titanium implant surfaces

In vitro evaluation of chemical decontamination of titanium discs

Influence of eight debridement techniques on three different titanium surfaces: A laboratory study

Manganese Oxide Nanozyme-Doped Diatom for Safe and Efficient Treatment of Peri-Implantitis.

Decontamination efficacy of antiseptic agents on in vivo grown biofilms on rough titanium surfaces

Controlled release of chlorhexidine from a mesoporous silica-containing macroporous titanium dental implant prevents microbial biofilm formation

Antifouling coatings for dental implants: Polyethylene glycol-like coatings on titanium by plasma polymerization

Surface Decontamination of Titanium Dental Implants Subjected to Implantoplasty by Treatment with Citric Acid Solutions

Antimicrobial efficiency and cytocompatibility of different decontamination methods on titanium and zirconium surfaces

Efficacy of Combined Mechanical and Chemical Decontamination Treatments on Smooth and Rough Titanium Surfaces and Their Effects on Osteoconduction: An Ex Vivo Study

Bioresorbable Polyester Coatings with Antifouling and Antimicrobial Properties for Prevention of Biofilm Formation in Early Stage Infections on Ti6Al4V Hard-Tissue Implants

The biofilm removal effect and osteogenic potential on the titanium surface by electrolytic cleaning: An in vitro comparison of electrolytic parameters and five techniques

Emerging titanium surface modifications: The war against polymicrobial infections on dental implants

Elimination of methicillin-resistant Staphylococcus aureus biofilms on titanium implants via photothermally-triggered nitric oxide and immunotherapy for enhanced osseointegration