Abstract:Using wood biomass as opposed to petroleum/fossil feedstock to synthesize chemicals and monomers offers the value proposition of a reduced carbon foot print. A critical step in biomass utilization is to obtain the fermentable monomeric pentose and hexose sugar subunits from various lig-nocellulosic polymers. However, lignin is a three-dimensional amorphous polymer based on methoxylated phenylpropanoid units, and is crosslinks to different polysaccharides with covalent bond. The presence of lignin is a barrier to enzymatic hydrosis of cellulose by cellulases, as well as inhibiting fermentation to form products such as ethanol. Usually, there are three approaches to fractionate biomass into useful chemicals. The first one is extract lignin at high temperature and pressure. The second approach involves more severe conditions such as the temperatures and pressures used in gasification, or use the mineral acids at elevated temperatures to liberate sugars for fermentation. The third way is dissolution of biomass using ionic liquid to extract lignin, and then re-precipitation the cellulosic residue. In this paper, we investigate the lignin extraction uses a purpose designed ionic liquid (IL) 1 -butyl-3-methylimidazolium acesulfamate [BMIM]Ace at room temperature and open atmosphere. It was synthesized from the sugar acesulfamate potassium (Ace K), and with good property of greater thermal stability, increased viscosities, and inability to dissolve crystalline cellulose. In addition, it is of low cost and nontoxic, and is expected to interact with lignin owing to its aromatic character of anion. Organic solvents were firstly used in the extraction process, which reduce the viscosity of IL and increase the lignin yield. The lignin can be obtained by using acetone as the reconstitution solvent (IL/acetone 1:3, v/v), and approximately 11.5% and 96.5% of lignin and the reconstitution cellulose-rich material have been achieved in one dissolution/reconstitution cycle by fresh IL, respectively. It was found that the presence of some organic solvents mix with IL can increase the extraction efficiency. The regenerated ionic liquid showed good retention of structure and properties. The regenerated lignin fractions exhibited large molecular weights (M-w, 3700-7810 g mol(-1)). The physicochemical properties of the extracted lignin fractions were characterized by Fourier transform infrared (FT-IR), and high-performance anion exchange chromatography (HPAEC). The reconstitution cellulose-rich material can be serving as a valuable source for enzymatic saccharification for next step. These results indicate a potential approach in further optimization of the choice of low-cost Its combined with organic solvents for the efficient utilization of the wood biomass.

A novel liquid-liquid phase-change solvent with upper critical solution temperature for simultaneous pretreatment and separation of lignin, cellulose and hemicellulose from lignocellulosic biomass

Exploration of deep eutectic solvent-based biphasic system for furfural production and enhancing enzymatic hydrolysis: Chemical, topochemical, and morphological changes

Lewis acid-catalyzed biphasic 2-methyltetrahydrofuran/H2O pretreatment of lignocelluloses to enhance cellulose enzymatic hydrolysis and lignin valorization

Benzenesulfonic acid-based hydrotropic system for achieving lignocellulose separation and utilization under mild conditions

Fractionation of poplar through solid acid pretreatment assisted by mild alkali-1-butanol immersion to effectively produce xylose, glucose, and solid lignin

Extrusion process to enhance the pretreatment effect of ionic liquid for improving enzymatic hydrolysis of lignocellulosic biomass

Evaluation of Organosolv Pretreatment on the Structural Characteristics of Lignin Polymers and Follow-Up Enzymatic Hydrolysis of the Substrates from Eucalyptus Wood.

Combined supercritical and subcritical process for cellulose hydrolysis to fermentable hexoses.

Selective Separation and Recovery of the Lignin from Lignocellulosic Biomass Using Ionic Liquid

Integrated Production Of Ethanol, Microbial Oil And Lignin From Lignocellulosic Biomass

Tandem Character of Liquid Hot Water and Deep Eutectic Solvent to Enhance Lignocellulose Deconstruction

Dissolution pretreatment of cellulose by using levulinic acid-based protic ionic liquids towards enhanced enzymatic hydrolysis

Solvent-based Delignification and Decrystallization of Wheat Straw for Efficient Enzymatic Hydrolysis of Cellulose and Ethanol Production with Low Cellulase Loadings

A mild biomass pretreatment process with efficiency and specificity in co-solvent of γ-valerolactone and aqueous p-toluenesulfonic acid

Biocompatible organosolv fractionation via a novel alkaline lignin-first strategy towards lignocellulose valorization

Efficient removal of surface-deposited pseudo-lignin and lignin droplets by isothermal phase separation during hydrolysis

Extraction Of Lignin From Wood Biomass Using A New Ionic Liquid At Open Atmosphere

An efficient microwave-assisted method using ethyl lactate/water cosolvent for lignocellulosic biomass fractionation

Supercritical Pretreatment and Hydrolyzation of Cellulose

The Breakdown of Reticent Biomass to Soluble Components and Their Conversion to Levulinic Acid As A Fuel Precursor

Acidic deep eutectic solvent assisted mechanochemical delignification of lignocellulosic biomass at room temperature