Abstract:Bisphenol analogues (BPs) are commonly found in riverine and coastal waters. However, the lack of a reliable and robust passive sampling method has hindered our ability to monitor these compounds in aquatic systems. The study developed a novel organic-diffusive gradients in thin film (o-DGT) sampler based on stainless steel mesh membrane, polyacrylamide diffusive gel, and hydrophilic-lipophilic balance (HLB) binding gel. This innovative design tackled issues of filter membrane sorption in traditional o-DGT devices and potential gel damage in membrane-less o-DGT devices, showing promising application prospects. The mass accumulation of 15 target BPs was linear over 10 days in both freshwater (r2 ≥ 0.92) and seawater (r2 ≥ 0.94), with no saturation observed. The diffusion coefficients (D) through polyacrylamide diffusive gels ranged from 4.04 × 10-6 to 5.77 × 10-6 cm2 s-1 in freshwater and from 1.74 × 10-6 to 4.69 × 10-6 cm2 s-1 in seawater for the target BPs (except for bisphenol PH) at 22 °C. The D values of the target BPs in seawater were lower than those in freshwater due to the high salinity in seawater (35 ‰). The o-DGT samplers demonstrated good integrity in field applications. The total concentrations of the eight detected BPs ranged from 9.2 to 323 ng L-1, which was consistent with the measurements obtained by grab sampling. Among all BPs, bisphenol S, bisphenol F, and bisphenol A were consistently detected at all sites using both sampling methods. The concentrations of some novel BPs in coastal water measured by grab sampling were comparable to those measured in rivers, suggesting the need to strengthen pollution control of BPs in coastal areas. These results indicate that the o-DGT passive sampling method developed in the present study can be effectively used for monitoring BPs in freshwater and coastal environments.

Recent Advances and Applications of Passive Sampling Devices

From capture to detection: A critical review of passive sampling techniques for pathogen surveillance in water and wastewater

Passive sampling as a tool for obtaining reliable analytical information in environmental quality monitoring

Passive Samplers, an Important Tool for Continuous Monitoring of the COVID-19 Pandemic

Field application of a novel active-passive sampling technique for the simultaneous measurement of a wide range of contaminants in water

Application of SPMD in Monitoring and Assessment of Organic Pollutants in Water (take PAH as example)

Use of Passive and Grab Sampling and High-Resolution Mass Spectrometry for Non-Targeted Analysis of Emerging Contaminants and Their Semi-Quantification in Water

Recent Advances in Aptamer Sensors

Field evaluation of diffusive gradients in thin-film passive samplers for wastewater-based epidemiology

Comparison of liquid and filter sampling techniques for recovery of Bacillus spores and Escherichia coli from environmental water

Recent advances in electrochemical sensor developments for detecting emerging pollutant in water environment

Rapid Detection Methods for Bacterial Pathogens in Ambient Waters at the Point of Sample Collection: A Brief Review

Utility of a modified o-DGT passive sampler for measurement of bisphenol analogues in freshwater and coastal waters

Recent Advances in Aptamer Discovery and Applications

A review of deep-seawater samplers: Principles, applications, performance, and trends

On-Site Bioaerosol Sampling and Airborne Microorganism Detection Technologies

Application of passive sampling device for exploring the occurrence, distribution, and risk of pharmaceuticals and pesticides in surface water

Recent advances in monitoring, sampling, and sensing techniques for bioaerosols in the atmosphere.

Recent Advances in Biosensor Technology for Potential Applications – An Overview

A Review of Current and Emerging Approaches for Water Pollution Monitoring

Evaluation of Chemcatcher® passive samplers for pesticide monitoring using high-frequency catchment scale data