Abstract:The harm goafs and other underground cavities cause to roads, which could lead to secondary geological hazards, has attracted increased attention. This study focuses on developing and evaluating the effectiveness of foamed lightweight soil grouting material for goaf treatment. The study examines the foam stability of different foaming agent dilution ratios by analyzing foam density, foaming ratio, settlement distance, and bleeding volume. The results show that there is no significant variation in foam settlement distance for different dilution ratios, and the difference in foaming ratio does not exceed 0.4 times. However, the bleeding volume is positively correlated with the dilution ratio of the foaming agent. At a dilution ratio of 60×, the bleeding volume is about 1.5 times greater than that at 40×, which reduces foam stability. Furthermore, an appropriate amount of sodium dodecyl benzene sulfonate improves both the foaming ability of the foaming agent and the stability of the foam. Additionally, this study investigates how the water–solid ratio affects the basic physical properties, water absorption, and stability of foamed lightweight soil. Foamed lightweight soil with target volumetric weights of 6.0 kN/m3 and 7.0 kN/m3 meet the flow value requirement of 170~190 mm when the water–solid ratio ranges are set at 1:1.6~1:1.9 and 1:1.9~1:2.0, respectively. With an increasing proportion of solids in the water–solid ratio, the unconfined compressive strength initially increases and then decreases after 7 and 28 days, reaching its maximum value when the water–solid ratio is between 1:1.7 and 1:1.8. The values of unconfined compressive strength at 28 days are approximately 1.5–2 times higher than those at 7 days. When the water ratio is excessively high, the water absorption rate of foamed lightweight soil increases, resulting in the formation of connected pores inside the material. Therefore, the water–solid ratio should not be set at 1:1.6. During the dry–wet cycle test, the unconfined compressive strength of foamed lightweight soil decreases, but the rate of strength loss is relatively low. The prepared foamed lightweight soil meets the durability requirements during dry–wet cycles. The outcomes of this study may aid the development of enhanced approaches for goaf treatment using foamed lightweight soil grout material.

Development of fiber compound foaming agent and experimental study on application performance of foamed lightweight soil

Experimental Study on Application Performance of Foamed Concrete Prepared Based on a New Composite Foaming Agent

Extrusion Foaming Of Lightweight Polystyrene Composite Foams With Controllable Cellular Structure For Sound Absorption Application

Multiporous Microstructure for Enhancing the Water Absorption and Swelling Rate in Poly(sodium Acrylic Acid) Superabsorbent Hydrogels Based on a Novel Physical and Chemical Composite Foaming System

Optimization of Formula for Stabilizing Muddy Soil Using Response Surface Methodology

Study on the Effect of Foam Stability on the Properties of Foamed Lightweight Soils

Study on Preparation and Performance of Foamed Lightweight Soil Grouting Material for Goaf Treatment

Animal-Protein-Based and Synthetic-Based Foamed Mixture Lightweight Soil Doped with Bauxite Tailings: Macro and Microscopic Properties

Experimental study on performance improvement of anionic surfactant foaming agent by xanthan gum

Preparation and Application of Foaming Agent Based on the Compound System of Short-Chain Fluorocarbon and Soybean Residue Protein

Mechanical Properties and Optimal Mix Design of Phosphogypsum Cement Mineral Admixture Foam Light Soil

Proportion and Performance Optimization of Lightweight Foamed Phosphogypsum Material Based on an Orthogonal Experiment

Effect of Cementitious Material Composition on the Performance of Low-Carbon Foamed Lightweight Soil

Preparation of foam concrete from solid wastes: Physical properties and foam stability

Research on performance of the concrete foaming agent

Aggregation behavior and foam properties of the mixture of hydrocarbon and fluorocarbon surfactants with addition of nanoparticles

Engineering Properties and Applications of Air-Foamed Lightweight Soil

Features of Processes for Preparation and Performance of Foamed Lightweight Soil with Steel Slag Micronized Powder and Granulated Blast Furnace Slag

Molecular Dynamics Simulation of the Synergistic Effect of Alkali/Surfactant/Polymer on the Formation and Stabilization of Water-Based Foam Systems

Effect of Surface Tension, Foaming Stabilizer, and Graphene Oxide on the Properties of Foamed Paste

Study on Alkali-Activated Prefabricated Building Recycled Concrete Powder for Foamed Lightweight Soils