Abstract:The quadrocopter’s design and configuration that capable to carry a payload of up to 30 kg based on the Pixhawk 2 Cube flight controller using Arducopter ver.4.1.5 firmware for FMUv3 devices was completed in the paper. For ensuring a flight range of 10-12 km, the using of 44000 mAh battery and payload of 10-15 kg is recommended. It has been established that when building large-sized copters, before setting up the PID controller, it’s necessary to pre-configure the parameters that are used by the PID controller. The failure to do so will often cause the aircraft to crash on its first flight. These are motor thrust linearization parameters, acceleration values for different axes and filters that go to the input of the PID controller. Experimentally tested the stability of the quadrocopter’s flight in windy weather in navigation modes for firmware Arducopter ver.4.1.5. At wind speeds up to 10 m/s with gusts up to 14-15 m/s, the flight stability was noted in automatic mode and in automatic return to the starting point mode. The high accuracy of the operation of the Ardupilot firmware navigation system was established when the cargo drop point was reached in automatic mode. The error was no more than 1.0-1.5 m at wind speed of 6-7 m/s. The effectiveness of mechanical vibration isolation for flight controllers of the Pixhawk Cube family has been experimentally established. When installing them on the frame of the copter, there is no need to use mechanical vibration decoupling. However, taking into account the low frequency of the frame oscillations from the operation of the propeller group (about 30 Hz), it’s necessary to design the frame with the frequency of natural oscillations outside this range. The using of software dynamic notch filters to reduce the impact of vibrations from running motors on the readings of the accelerometer and gyroscope is considered. On the frame of 2000 mm quadrocopter, it’s shown that such filters significantly reduce the amplitude of not only the detected fundamental frequency, but also their harmonics. The various ways of setting up actuators controlled by servos and relays for dropping loads, switching operating modes by video systems, switching on and off spraying mechanisms when using such drones in agriculture are considered.

Enhancing Autonomous Drones With Self- Designed Payload Dropping Mechanism

TIE: an Autonomous and Adaptive Terrestrial-Aerial Quadrotor

Lowering Barriers to Entry for Fully-Integrated Custom Payloads on a DJI Matrice

A payload based detail study on design and simulation of hexacopter drone

Autonomous Multi-Rotor UAVs: A Holistic Approach to Design, Optimization, and Fabrication

Design and Development of Automated Self Recoverable Drone

A Model Design in UAV Technology: A Multi-controller-based Wi-Fi Imaging Drone

Al Based Automatic alarm Generation and Dropping of Payload at a Particular Object through a Drone

Design and Development of Autonomous Delivery Drone

Advanced Autonomy on a Low-Cost Educational Drone Platform

Integrated Design and Control of a Robotic Arm on a Quadcopter for Enhanced Package Delivery

Design and Fabrication of Emergency Drone Recovery System

AirPilot: Interpretable PPO-based DRL Auto-Tuned Nonlinear PID Drone Controller for Robust Autonomous Flights

An Embedded Platform for Positioning and Obstacle Detection for Small Unmanned Aerial Vehicles

Design, control, aerodynamic performances, and structural integrity investigations of compact ducted drone with co-axial propeller for high altitude surveillance

A Novel Drone Design Based on a Reconfigurable Unmanned Aerial Vehicle for Wildfire Management

An Open-source Hardware/Software Architecture and Supporting Simulation Environment to Perform Human FPV Flight Demonstrations for Unmanned Aerial Vehicle Autonomy

Structural Design and Flight Simulation of Firefighting and Rescue UAV Based on Coaxial Dual Rotors

Automated Drone Delivery System

LARGE-CAPACITY QUADCOPTER’S DESIGNING ON THE CONTROLLERS OF THE PIXHAWK CUBE FAMILY

Reconfigurable Drone System for Transportation of Parcels With Variable Mass and Size