An Improved Single-Phase Multiple DC Source Inverter Topology for Distributed Energy System Applications

Mohd Faraz Ahmad,M. Saad Bin Arif,Uvais Mustafa,Mohamed Abdelrahem,Jose Rodriguez,Shahrin Md. Ayob

DOI: https://doi.org/10.3390/en17092146

IF: 3.2

2024-04-30

Energies

Abstract:This work presents an improved structure of a single-phase muti-input multilevel inverter (MIMLI) for distributed energy resources, which is capable of producing a nine-level output in symmetric mode and 21 levels in asymmetrical mode. The topology uses four DC sources and ten switches, with four switches being bidirectional and the remaining unidirectional. The operation of the circuit is analyzed in an asymmetrical mode, and switching signals are accomplished using the Nearest Level Control (NLC) PWM technique. Depending on the value of the DC sources used, the number of levels can vary. In this work, different DC source algorithms were also proposed, and the analysis of the inverter has been carried out considering the algorithms producing the maximum number of levels. The inverter was simulated in MATLAB/Simulink under steady state and dynamic conditions, achieving a 3.89% THD in output. The thermal analysis was conducted using PLECS software 4.1.2 to assess losses and efficiency. A laboratory prototype of the proposed topology was developed and tested, confirming its performance through simulation results and proving it economically viable for medium- and high-power applications.

energy & fuels

What problem does this paper attempt to address?

### Problems Addressed by the Paper

This paper aims to develop an improved single-phase multi-DC source inverter topology for Distributed Energy Resources (DERs). Specifically, the study addresses the following issues:

1. **Reduction in the Number of Devices**:
- Traditional Multilevel Inverters (MLIs) such as Cascaded H-Bridge (CHB), Neutral Point Clamped (NPC-MLI), and Flying Capacitors (FC-MLI) have advantages like modularity and ease of control but require a large number of power switches to generate multiple voltage levels, and the voltage control mechanism is complex.
- This paper proposes a new topology that uses only 4 DC sources and 10 switches (4 of which are bidirectional switches) to generate 9 output voltage levels in symmetric mode and 21 output voltage levels in asymmetric mode.

2. **Improvement in Efficiency and Reliability**:
- At any given voltage level, only 3 switches are in the on-state, reducing conduction losses and improving the overall efficiency of the inverter.
- Redundant states provide a more reliable and fault-tolerant topology.

3. **Reduction in Total Standing Voltage (TSV)**:
- By optimizing the switch layout, the TSV is kept low, allowing the use of lower-rated switches, thereby reducing system costs.

4. **Simplification of Control Algorithms**:
- Different DC source selection algorithms are proposed to generate different numbers of output voltage levels, and the Nearest Level Control (NLC) Pulse Width Modulation (PWM) technique is used for switch operation.

5. **Economic Feasibility Analysis**:
- The performance of the topology is validated through MATLAB/Simulink simulations and experimental verification, including thermal analysis and efficiency evaluation, proving its suitability for medium to high power applications.

In summary, this paper is dedicated to developing a cost-effective, device-efficient single-phase multi-DC source inverter topology capable of generating multiple voltage levels.