Decoupling experiments for CH4 “diffusion-seepage” in coal columns to effectively measure sorption time
Qingquan Liu,Wenyi Huang,Biao Lv,Xiaohang Ma,Xiaodong Lu,Jing Wang,Liang Wang
DOI: https://doi.org/10.1016/j.coal.2022.104074
IF: 6.3
2022-09-01
International Journal of Coal Geology
Abstract:Sorption time is a key parameter for calculating the gas mass exchange between the matrix and the fracture system of coal, and which is generally defined as the time taken for coals to desorbed 63.2% of the total adsorbed CH4. It's usually measured through CH4 isothermal adsorption-desorption experiments with coal particles or blocks. However, the conventional method has many problems in determining the sorption time, including (1) over the experiments, due to the presence of adsorption-desorption hysteresis, the residual gas may be >36.8% of the adsorbed volume, which makes it impossible to determine the sorption time, and (2) the sorption time test results for granular coals have a significant particle-size effect, while for coal blocks they’re affected by the seepage behavior because all measured desorption parameters undergo the coupled “diffusion-seepage” motion. Therefore, this study conducted a series of experiments in coal columns with pre-fabricated holes to decouple the “diffusion-seepage” behavior and calculate sorption time by a new method. Coal columns with pre-fabricated holes modified the seepage channels while hardly altering the diffusion pore system, which achieves the quantification of the seepage behavior. As observed, the equilibrium time of CH4 was found to be much longer than of He. It suggests that the diffusion process is the master factor for the CH4 adsorption equilibrium in coal. Comparing the gas desorption rates of the coal columns, in the first 62.5–67.5 min the differences among desorption rates were large, while afterward the differences disappeared. It is inferred that the desorption process in the earlier stage is controlled by seepage behavior, while dominated by diffusion in the later stage of the gas transport. The key point of the new method is to acquire the diffusion-dominated CH4 desorption volume by eliminating the effect of seepage behavior. The sorption time in this study was calculated directly by the interporosity flow function, which ranged from 266.4 min to 276.4 min. The new method can avoid many problems of a conventional method and is highly scalable.
energy & fuels,geosciences, multidisciplinary