Abstract:Nowadays, consumer trends towards healthier and low fat products have a significant impact on the deep fat frying industry. The objective of this study was to design a modified deep fat fryer (MDF) to have a smaller surface area relative to height, with made a steam blanketing over the fryer. Different levels of water injection flow rates have been used (0.1, 0.2 and 0.3 ml/20 min. per 1 liter of tested oil), compared with conventional fryers (CDF). Frying was conducted at 170 ± 10 °C into sunflower oil using CDF (H√A = 0.24) and MDF (H√A = 0.8) in batch 8 min. 16 batches every day (eight hrs. /day)for up to 40 hrs (Consecutive five days). The modification was intended to related oil deterioration. Water injection had a dual effect. In comparison with CDF, water injection increased the acidity (expressed as oleic acid) from 0.34 % to 0.97 %, after 40 hrs at 170 ± 10 °C of deep fat frying, and a contrarily, the protective role was observed in all the other quality indices. Significant reductions in TBA values (from 8.9 to 4.81mg malonaldehyde/liter of tested oil), P-anisidine values (from 35.6 to 12.9), TPC contents (from 34.5% to 18.64%), conjugated diene (232 nm) (from 8 to 5.59) and conjugated triene (268 nm) (from 1.9 to 1.33) were recorded in sunflower oil compared with CDF. These quality indices of sunflower oil developed dramatically in the first level of water injection flow rate. Consequently, the first level of water injection had the highest (P≥0.05) inhibitory effect compared with the other levels of water injection. Fatty acid composition of fried oil properties during deep frying CDF and MDF designs were determined. There were significant differences (P≥0.05) of fatty acids composition between the fried oil induces during using of CDF and MDF designs. Total unsaturated fatty acid at MDF design gave the highest values. Also, organoleptic evaluation of fried potato chips by CDF and MDF were evaluated by panelists. Fried potato chips during the first level of water injection flow rate had the highest (P≥0.05) flavor (4), crisp (4.5), greasiness (4.6), and overall acceptability (4.8), compared with fried potato chips during other levels of water injection flow rates and with CDF. Findings suggest that determination of the oil quality indices are good makers of sensory evaluation during deep fat frying. Results indicated the changes in moisture content, oil uptake and shrinkage percentages of potato chips at different levels of water injection compared the control samples. The negative correlation coefficient between oil uptake and moisture content was high (r = -0.915) and linear regression equation for prediction the oil uptake y = 34.1064 – 2.0291X. Also, results suggest that during deep fat frying by MDF design may reduce the thermal deterioration of sunflower oil. Water injection can be applied as a simple method to improve oil quality during deep fat frying.

Regulating the use of degraded oil/fat in deep-fat/oil food frying

Determination and Removal of Malondialdehyde and Other 2-Thiobarbituric Acid Reactive Substances in Waste Cooking Oil

Quality investigation of the most consumed refined seed oils after French fries’ domestic short-term deep-frying process

Qualitative and Quantitative Analysis of Oxidative Degradation Products in Frying Oil by Three-Dimensional Fluorescence Spectroscopy with Metalloporphyrin-Based Sensor

Influence of steam singlet method on oil quality during deep fat frying on a modified fryer

The relationship between the deterioration of frying oil and the generation of hazards during frying

The occurrence of 3-monochloropropane-1,2-diol esters and glycidyl esters in vegetable oils during frying

Analysis of oxidation products and toxic compounds in edible and blended oil during the deep-frying of french fries

Frying Oil Evaluation by a Portable Sensor Based on Dielectric Constant Measurement

A review of different frying oils and oleogels as alternative frying media for fat-uptake reduction in deep-fat fried foods

Oxidation and Thermal Degradation of Oil during Frying: A Review of Natural Antioxidant Use

Recent advances in deep‐fat frying through pretreatments and edible coating to reduce oil absorption

Studies on Measuring Changes in Frying Oils

Comparative Analysis of the Effects of Domestic Frying and Storage on Some Selected Oil Samples from Local and Commercial Sources

Dynamic changes of fatty acids and related physical & chemical parameters during deep frying in fish oil supplemented blend oil

Evaluating the rancidity and quality of discarded oils in fast food restaurants

A review on the frying process: Methods, models and their mechanism and application in the food industry

Fast Detection of Fried Oil Quality by Electronic Nose

Deep-fat Frying of Vegetable Oils: Major Chemical Reactions and Effect of Natural Extracts on Oxidative Stability - A Review

Application of TESTO Rapid Testing Method on the Quality Monitoring of Repeated Usage of Frying Oil

Frying of Food: A Critical Review