Flows of plastic, energy, and carbon in a mechanical treatment plant for refuse-derived fuel production from landfill-mined waste
Zwe Yin Phyu,Awassada Phongphiphat,Anupong Muttaraid,Komsilp Wangyao,Sirintornthep Towprayoon
DOI: https://doi.org/10.1016/j.jclepro.2024.142065
IF: 11.1
2024-04-16
Journal of Cleaner Production
Abstract:Refuse-derived fuel (RDF) derived from landfill-mined waste (LMW) has attracted considerable interest among Thai entrepreneurs and energy-intensive industries in the past decade. LMW typically undergoes subsequent mechanical treatment (MT) to segregate valuable combustibles, thereby facilitating the production of RDF with high energy content. While RDF production from LMW via MT promotes material- and energy-recovery, it raises concerns about its economic feasibility, potential environmental contamination, dust and particulate emissions, greenhouse gas (GHG) emissions from fuel and electricity consumption, and social impacts. To gain better insight into this process, this study investigated the mass flow of inputs (LMW) and outputs (RDF, rejected RDF, rejected soil-like materials, recyclable materials, and non-recyclable materials) from RDF production lines of an MT plant in Thailand. All samples were weighed and analysed for their plastic, energy, and carbon content. The LMW, as received, has an average moisture content of 39.8%. The RDF production rate from this plant was 23.3 tonnes/hour, which is equivalent to 34.5% of the total LMW fed into the plant. Of the total LMW input, the byproducts included 11.9% rejected RDF, 52.3% rejected soil-like materials, 0.7% recyclable materials, and 0.6% non-recyclable materials. On average, the final RDF comprised mostly plastic (66–78%) and textile (10–18%). The estimated net calorific value of RDF ranged from 26.38 to 28.93 MJ/kg. In an hour, the MT process can recover 50% of the plastic waste (9.32 tonnes/hour), 49.9% of the energy in the form of RDF (353,734 MJ/h), and 39% of the carbon content (8.49 tonnes/hour) from the LMW inputs. Approximately 33% of plastic waste, 31% of energy, and 45% of carbon from the LMW inputs were found in the resulting rejected soil-like materials. The MT process could be optimised to reduce this leakage further. The total output energy, approximately 353,734 MJ/h, accounted for 50% of the total energy supplied to the MT processes. The findings are valuable for developing strategies to maximise waste recovery, minimise energy loss, increase profits, and reduce environmental impacts.
environmental sciences,green & sustainable science & technology,engineering, environmental