Abstract:Fission processes of the excited compound nuclei Tl197, Fr217, Th224 , and Fm254 in a wide range of mass numbers produced in fusion reactions have been simulated in the framework of the modified statistical model and different observables were reproduced for these nuclei. In the statistical calculations have been considered the effects of the projection of the total spin of the compound nucleus onto the symmetry axis K , the temperature dependence of the location and height of fission transition points, and the classical collective motion of the excited compound nuclei about the ground state. Furthermore, in the present research, particle binding energies as a function of deformation of nuclei and subbarrier fission have been considered for more accurate reproduction of the experimental data. The fission cross section, the evaporation residue cross section, the fission probability, the average prescission neutron multiplicity, and the anisotropy of fission fragments' angular distribution have been calculated for the excited compound nuclei Tl197, Fr217, Th224 , and Fm254 . In the statistical simulations, the scaling factor of the fission barrier height, rs , and the temperature coefficient of the effective potential, k , were considered as a free parameter. For each reaction the parameters rs and k were adjusted to reproduce a single fission cross section and a single evaporation residue cross section. It was shown that the results of calculations are in good agreement with the experimental data by using appropriate values for these parameters equal to k=0.0182±0.0050MeV−2 and rs=1.0005±0.0020 for Tl197 ; k=0.0063±0.0040MeV−2 and rs=1.0042±0.0015 for Fr217 ; k=0.0060±0.0040MeV−2 and rs=1.0050±0.0020 for Th224 ; k=0.0025±0.0015MeV−2 and rs=1.0100±0.0014 for Fm254 . Furthermore, by using appropriate values of parameters k and rs I have calculated the average prescission neutron multiplicity, the fission probability, and the anisotropy of fission fragments' angular distribution for the compound nuclei Tl197, Fr217, Th224 , and Fm254 . It was shown that the modified statistical model is well able to reproduce different experimental data, although at high excitation energies the results of calculations for the neutron multiplicity and the anisotropy of fission fragments' angular distribution are slightly lower than the experimental data. It was also shown that, at high excitation energy, for reproducing the neutron multiplicity one needs to increase the nuclear dissipation. Finally, from the comparison of the extracted results of parameters k and rs for the compound nuclei Tl197, Fr217, Th224 , and Fm254 , it was shown that the parameter k decreases and the parameter rs increases with increasing mass number of the compound nucleus. https://doi.org/10.1103/PhysRevC.109.064624 ©2024 American Physical Society

Fission Reaction Event Yield Algorithm FREYA 2.0.2

Identifying and overcoming deficiencies of nuclear data on the fission of light actinides by use of the GEF code

CGMF & FREYA Verification in Monte Carlo Code RMC

Fission Fragment Mass and Kinetic Energy Yields of Fermium Isotopes

Event-by-event evaluation of the prompt fission neutron spectrum from 239Pu(n, f)

Multimodal fission from self-consistent calculations

Photo-fission of 232Th and 238U at intermediate energies

To fission or not to fission

Fission fragment charge and mass distributions in 239Pu(n,f) in the adiabatic nuclear energy density functional theory

Verification of direct coupling code system using FRENDY version 2 and GENESIS for light water reactor lattices

Prompt emission calculations for 239Pu(nth,f) with the DSE model code and a pre-neutron fragment distribution Y(A,TKE) based on the four-dimensional Langevin model

Analysis of Fission Products' Release in Pebble-Bed High-Temperature Gas-Cooled Reactor Fuel Elements Using a Modified FRESCO II Numerical Model

A novel emulator for fission event generators

IRDFF-II: A New Neutron Metrology Library

Statistical modeling of the fission process of , and nuclei produced in heavy ion reactions within the modified statistical model

Extensive study of the quality of fission yields from experiment, evaluation and GEF for antineutrino studies and applications

A New Evaluation of Fission Product Yields for the Neutron Induced Fission of U-233 and Th-232

Extension of the Hauser-Feshbach Fission Fragment Decay Model to Multi-Chance Fission

r-Java 2.0: the nuclear physics

Angular Momentum of Fission Fragments from Microscopic Theory