Abstract:Due to the stratified construction of additive manufacturing (AM), the building orientation of an object greatly affects the manufacturing process and quality of the products. This article proposes an optimization algorithm for AM that comprehensively covers the three main aspects affected by the building direction: efficiency, surface quality, and internal properties. The goal of optimizing efficiency is to cut the manufacturing and postprocessing times by reducing the support volume. In terms of surface quality optimization, a new and comprehensive mathematical model is established. Considering not only the influence of the stepping effect on the whole model but also the supporting contact area, the optimization to the salient area was innovatively proposed. The salient area was defined by cone curvature, which has a significant influence on appearance. Another novel point is the quantitative optimization of the internal properties, which is based on the anisotropic characteristics of AM. The mechanical properties are taken into consideration in this article, and other anisotropic properties can be added to the optimization algorithm by using the same method. Afterward, a particle swarm optimization algorithm was adopted to synchronously optimize the targets just cited, according to the degree of importance of each factor for specific applications. The algorithm was implemented to optimize several different cases with different characteristics. Further, the results in the experiments manifested that the models printed in the optimized orientation performed better than the initial models, and the corresponding comprehensive evaluation scores were improved as well, with an optimization range of 70-90%. And the rate of optimization for support volume, surface roughness, salient area roughness, and maximum tensile strength, respectively, reached 20.9%, 57.3%, 59.5%, and 293.0%.

Build orientation optimization considering thermal distortion in additive manufacturing

Build Orientation Optimization for Extrusion-Based Additive Manufacturing Coupling with Adaptive Slicing

Multi-orientation Optimization of Complex Parts Based on Model Segmentation in Additive Manufacturing

Build Orientation Optimization Based on Weighted Analysis of Local Surface Region Curvature

Building Orientation Determination Based On Multi-Objective Optimization For Additive Manufacturing

Self-supporting Topology Optimization for Additive Manufacturing

Design and Validation of 3D Self-Supporting Structures and Printing Paths for Multi-Axis Additive Manufacturing

Topology Optimisation of Self-Supporting Structures Based on the Multi-Directional Additive Manufacturing Technique

Layout and Geometry Optimization Design for 3D Printing of Self-Supporting Structures

Self-supporting Structure Design with Feature-Driven Optimization Approach for Additive Manufacturing

A new method to select optimal part building orientation for additive manufacturing processes based on geometric complexity and heat shrinkage

Topology and build orientation optimization for additive manufacturing considering build height and overhang area

Part orientation optimization for Wire and Arc Additive Manufacturing process for convex and non-convex shapes

A post-topology optimization process for overhang elimination in additive manufacturing: design workflow and experimental investigation

Topology Optimization of Thermal Conductive Support Structures for Laser Additive Manufacturing

Manufacturability Oriented Model Correction and Build Direction Optimization for Additive Manufacturing

An Automatic Optimization Method for Minimizing Supporting Structures in Additive Manufacturing

Topology optimization of support structure layout in metal-based additive manufacturing accounting for thermal deformations

Concurrent topology optimization of parts and their supports for additive manufacturing with thermal deformation constraint

Additive manufacturing-driven design optimization: Building direction and structural topology

Multi-objective optimization of build orientation considering support structure volume and build time in laser powder bed fusion