Abstract:Abstract Drawdown and buildup data in a homogeneous, uniform, closed, cylindrical reservoir containing oil and gas and producing by solution gas drive at a constant surface oil rate were investigated. The well was assumed to be located at the center of the reservoir. Gravity effects were not included. Though the reservoir systems studied were assumed to be homogeneous, the effect of a damaged region in the vicinity of the wellbore was examined. Recently, alternate expressions for describing multiphase flow through porous media have been presented. These expressions incorporate changes presented. These expressions incorporate changes in effective permeability and fluid properties (formation volume factor, viscosity, gas solubility) with pressure by means of a pseudopressure function. The validity of applying the pseudopressure-function concept to drawdown and pseudopressure-function concept to drawdown and buildup testing for multiphase-flow situations was investigated. The pseudopressure function for analyzing drawdown behavior is calculated difrerently from that required to analyze buildup data. Consequently, two pseudopressure functions are required for analysis of well behavior in multiphase-flow systems. Dimensionless groups are used to extend the results to other situations having different permeabilities, spacing, reservoir thickness, well permeabilities, spacing, reservoir thickness, well radii, porosity, etc., provided the PVT relations and relative-permeability characteristics are identical to those used in this study. The pseudopressure-function concept used to analyze pseudopressure-function concept used to analyze drawdown and buildup behavior extends the applicability of the results to a wide range of PVT relations and relative-permeability characteristics. Introduction During the past 30 years, more than 300 publications have considered various problems publications have considered various problems pertaining to well behavior. Except for a few (about pertaining to well behavior. Except for a few (about 10), most papers examining transient pressure behavior assume that the fluids in the reservoir obey the diffusivity equation. This implies the use of a single-phase, slightly compressible fluid. The reason for the popularity of this approach is twofold:(1)the ease with which the diffusivity equation can be solved for a wide variety of problems, and(2)the demonstration by some problems, and(2)the demonstration by some workers that, for some multiphase-flow situations, single-phase flow results may be used provided appropriate modifications are made. The necessary modifications are summarized in Ref. 1. The main objective of this study is to present a method for rigorously incorporating changes in fluid properties and relative-permeability effects in the properties and relative-permeability effects in the analysis of pressure data when two phases of oil and gas are flowing. This should enable the engineer to calculate the absolute formation permeability rather than the effective permeability to each of the flowing phases. This method is based on an idea suggested by Fetkovich, who proposed that if an expression similar to the real gas pseudopressure is defined, then equations describing pseudopressure is defined, then equations describing simultaneous flow of oil and gas through porous media may be simplified considerably. The validity of the equations and methods for calculating the pseudopressure function, however, was not presented pseudopressure function, however, was not presented by Fetkovich. LITERATURE REVIEW AND THEORETICAL CONSIDERATIONS General equations of motion describing multiphase flow in porous media have been known since 1936. These equations, and the assumptions involved in deriving them, are discussed thoroughly in the literature and will not be considered here. Equations for two-phase flow were first solved by Muskat and Meres for a few special cases. Evinger and Muskat studied the effect of multiphase flow on the productivity index of a well and examined the steady radial flow of oil and gas in a porous medium. Under conditions of steady radial porous medium. Under conditions of steady radial flow the oil flow rate is given by (1) SPEJ P. 196

New Solutions for Well-Test-Analysis Problems: Part 1—Analytical Considerations

Analytical Solution for Tunnelling-Induced Response of an Overlying Pipeline Considering Gap Formation

Application of Hankel Transforms to Boundary Value Problems of Water Flow Due to a Circular Source.

Generalized Analytical Well-Test Solutions for Vertically Fractured Wells in Commingled Reservoirs

Practical pressure-transient analysis solutions for a well intercepted by finite conductivity vertical fracture in naturally fractured reservoirs

Analytical Solution for Steady-State Groundwater Inflow into a Circular Tunnel in Anisotropic Soils

Pressure transient analysis of a fractured well in multi-region linear composite reservoirs

New Analytical Solutions for Constant Rate Pumping in Two‐Zone Double‐Porosity Confined Aquifer: A New Source Term Reflecting Effects of Well Skin and Wellbore Storage

A quick analysis approach for early-time well test data of vertically fractured wells: Applications in Changqing oilfield, China

Adaptive identification and interpretation of pressure transient tests of horizontal wells: challenges and perspectives

A Semi-Analytic Solution of a Wellbore in a Non-Isothermal Low-Permeability Porous Medium under Non-Hydrostatic Stresses

Well Test Analysis: Wells Producing by Solution Gas Drive

An Analytical Solution for the Transient Response of a Semi-Infinite Elastic Medium with a Buried Arbitrary Cylindrical Line Source

Analytical Solution for the Transient Response of a Fluid/saturated Porous Medium Half-Space System Subjected to an Impulsive Line Source

Analytical Model for Rate Transient Analysis in Low-Permeability Volatile Oil Reservoirs

An Analysis of Oil Well Testing for Non-Newtonian Fluid in a Fracture-Dominated Reservoir

A novel pressure transient analysis model for fracturing wells in fracture–cavity carbonate reservoirs

Pressure transient analysis of a vertical well with multiple etched fractures in carbonate reservoirs

An Analytical Method for Determining the Bottom‐Hole Pressure of Vertical Well With Multiple Fractures

A NEW WELL TEST ANALYSIS TECHNIQUE FOR GAS WELLS WITH LIQUID YIELD EFFECTS

Dynamic Pressure Analysis of Shale Gas Wells Considering Three-Dimensional Distribution and Properties of the Hydraulic Fracture Network