Abstract:The chemical composition and structure of the solid electrolyte interphase (SEI) are two of the key factors that determine the reversibility of lithium-metal (Li) anodes for next-generation batteries. As a result, much of the research aimed at enabling practical Li-metal batteries emphasizes tuning SEI composition, either via electrolyte formulation 1–5 or synthesis of artificial SEIs. 6–8 Ideally, the lithium SEI should minimize parasitic side reactions by effectively passivating Li while also promoting facile conduction of lithium ions (Li + ). To do this, SEI materials must have high (electro)chemical stability, be ionically conductive, and be sufficiently mechanically robust to accommodate substantial volume changes. However, studying these properties in bulk-scale materials often yields values that diverge by orders of magnitude from those observed in SEIs. For example, typical SEI ionic conductivities lie in the range of 10 -7 -10 -9 S cm -1 , yet bulk ionic conductivity measurements of relevant materials such as lithium carbonate, lithium fluoride, and lithium oxide ranges from 10 -18 and 10 -10 S cm -1 . 9 Our group has developed a technique to directly study these materials at realistic length scales by synthesizing model interphases through the reaction of gases with Li. 10,11 Our previous work on Li 2 O and LiF revealed that Li 2 O is a better Li + conductor than LiF (~1 x 10 -9 S cm -1 vs ~5.2 x 10 -10 S cm -1 ), 11 and that these species’ chemical stability varies substantially in different electrolytes. 12 One of the remaining key SEI materials is lithium carbonate, which has been proposed to act as a metastable phase in the outer portion of the SEI. 13 In this work, we have developed a technique to synthesize Li 2 CO 3 films via sequential reaction of oxygen and carbon dioxide with clean lithium surfaces. Using scanning electron microscopy and air-exposure tests, we can confirm that these films are conformal and generally pinhole-free. Titration gas chromatography (TGC) 14 was used to quantify relative proportions of lithium carbonate, metallic lithium, and lithium carbide, and X-ray photoelectron spectroscopy (XPS) offers insights into how composition changes across the depth of the film. These films were then used as a platform to further investigate the reactivity of Li 2 CO 3 with different electrolytes, comparing carbonates versus ethers and varying the lithium salt used. Electrochemical impedance spectroscopy (EIS) offers insights into the evolution of transport properties at these interphases, while electrolyte soak tests coupled with gas chromatography of gas-phase products and TGC of solid-phase products can track their chemical evolution. Taken together, this work illuminates how lithium carbonate may evolve during battery cycling, offering perspective that can help guide future design of Li-metal SEIs. References Liu, Y. et al. Solubility-mediated sustained release enabling nitrate additive in carbonate electrolytes for stable lithium metal anode. Nat. Commun. 1–10 (2018). Suo, L. et al. Fluorine-donating electrolytes enable highly reversible 5-V-class Li metal batteries. Proc. Natl. Acad. Sci. 115 , 1156–1161 (2018). Chae, O. B., Adiraju, V. A. K. & Lucht, B. L. Lithium Cyano Tris(2,2,2-trifluoroethyl) Borate as a Multifunctional Electrolyte Additive for High-Performance Lithium Metal Batteries. ACS Energy Lett. 6 , 3851–3857 (2021). Li, Y. et al. Correlating Structure and Function of Battery Interphases at Atomic Resolution Using Cryoelectron Microscopy. Joule 2 , 2167–2177 (2018). Zhao, Q. et al. Upgrading Carbonate Electrolytes for Ultra‐stable Practical Lithium Metal Batteries. Angew. Chemie Int. Ed. 61 , e2021162 (2021). Zhao, J. et al. Surface Fluorination of Reactive Battery Anode Materials for Enhanced Stability. J. Am. Chem. Soc. 139 , 11550–11558 (2017). Li, Y. et al. Robust Pinhole-free Li3N solid electrolyte grown from molten lithium. ACS Cent. Sci. 4 , 97–104 (2018). Kozen, A. C. et al. Next-Generation Lithium Metal Anode Engineering via Atomic Layer Deposition. ACS Nano 9 , 5884–5892 (2015). Lorger, S., Narita, K., Usiskin, R. & Maier Films of Li, J. Enhanced ion transport in Li2O and Li2S films. Chem. Commun 57 , 6503–6506 (2021). He, M., Guo, R., Hobold, G. M., Gao, H. & Gallant, B. M. The intrinsic behavior of lithium fluoride in solid electrolyte interphases on lithium. PNAS 117 , 73–79 (2020). Guo, R. & Gallant, B. M. Li 2 O Solid Electrolyte Interphase: Probing Transport Properties at the Chemical Potential of Lithium. Chem. Mater 32 , 5525–5533 (2020). Guo, R., Wang, D., Zuin, L. & Gallant, B. M. Reactivity and Evolution of Ionic Phases in the Lithium Solid−Electrolyte Interphase. ACS Energy Lett. 877–885 (2021) doi:10.1021/acsenergylett.1c00117. Han, B. et al. Poor Stability of Li2CO3 in the Solid Electrolyte Interphase of a Lithium-Metal Anode Revealed by Cryo-Electron Microscopy. Adv. Mater. 33 , 2100404 (2021). Hobold, G. M. & Gallant, B. M. Quantifying Capacity Loss Mechanisms of Li Metal Anodes beyond Inactive Li0. ACS Energy Lett. 4 , 3458–3466 (2022).

Electrochemical Characterization of Thiophosphate- Ionic Liquid Hybrid Lithium Electrolytes Against Li Metal

A Bifunctional Composite Artificial Solid Electrolyte Interphase for High Stable Solid-State Lithium Batteries

Exploring the Efficiency of Lithium Stripping/Plating in Solid Polymer Anode-Free Lithium Cells

Boosting the Interfacial Stability of the Li6PS5Cl Electrolyte with a Li Anode via In Situ Formation of a LiF-Rich SEI Layer and a Ductile Sulfide Composite Solid Electrolyte

(Invited) Interfaces in Solid-State Batteries

Engineering a Dynamic Solvent-Phobic Liquid Electrolyte Interphase for Long-Life Lithium Metal Batteries

Probing the Stability of Lithium Carbonate in the Lithium-Metal Solid Electrolyte Interphase

Stabilizing Ceramic-Based Electrolyte Interfaces with Self-Viscous Modification Strategy for Solid-State Lithium Batteries

Reinforcing the Li|Li1.3Al0.3Ti1.7(PO4)3 Interfacial Stability by an Ultrathin Multifunctional Polysiloxane-Based Single-Ion Conducting Polymer

Organic–Inorganic Hybrid SEI Induced by a New Lithium Salt for High-Performance Metallic Lithium Anodes

Stable Lithium Metal Batteries Enabled by Dilute Cationic Additives

Trimethylsilyl Compounds for the Interfacial Stabilization of Thiophosphate-Based Solid Electrolytes in All-Solid-State Batteries

Conception of Hybrid Organic-Inorganic Membrane as New Electrolyte in All Solid-State Battery

Locally Concentrated Ionic Liquid Electrolytes for Lithium/Sulfurized Polyacrylonitrile Batteries

Properties of the Interphase Formed between Argyrodite-Type Li6PS5Cl and Polymer-Based PEO10:LiTFSI

A Hybrid-Salt Strategy for Modulating the Li+ Solvation Sheathes and Constructing Robust SEI in Non-Flammable Electrolyte Lithium Metal Batteries

Interface Engineering Via Fluorinated Solid Electrolytes for All-Solid-State Li Batteries

Resolving anodic and cathodic interface-incompatibility in solid-state lithium metal battery via interface infiltration of designed liquid electrolytes

Synergistic Approach toward Developing Highly Compatible Garnet‐Liquid Electrolyte Interphase in Hybrid Solid‐State Lithium‐Metal Batteries

Boosting the Performance of Lithium Batteries with Solid-Liquid Hybrid Electrolytes: Interfacial Properties and Effects of Liquid Electrolytes

Phosphonium-Based Ionic Liquid Electrolyte in Combination with Silicon Anodes and LiNi0.5-XMn1.5+XO4 Cathodes for Lithium Ion Batteries