Abstract:A wide variety of complicated material removal methods and cutting tools have been employed in the field of mold forming. An insight should be gained into the action law of basic cutting parameters and tool structure on cutting force, which lays a solid basis for the design of machine tools, tools and fixtures in mold high-performance manufacturing. In this study, an analytical model of milling force for milling H13 steel is built by combining the multi-physical field calculation method of cutting deformation zone and the equivalent cutting edge theory. A multi physical field calculation method for the first deformation zone is proposed in combination with the common correlation between the equal and unequal models of the main shear zone. The model correctly indicates the distribution characteristics of temperature and stress in the shear zone, consistent with the distribution of the two-dimensional (2D) finite element model. Given the changes of cutting parameters and tool geometric angles, the chip flow angle prediction model of different tool-chip contact states is built. The oblique cutting force prediction model is implemented through coordinate conversion based on the equivalent cutting edge. The interaction mechanism of tool geometry and tool angle on cutting force components is revealed, respectively. A mechanical model of the three-dimensional (3D) face milling process of H13 steel is built to more effectively verify the feasibility of the machining mechanical model, and the effect of milling parameters on the milling process force is expressed. The correctness of the model was verified by experimentally measuring the milling force. The built analytical cutting force model can lay a theoretical basis for the recommendation of reasonable tool structure and milling parameters for H13 steel.

Analytical modeling of Poisson burr formation in the machining of Al6061 with interface constraint

Clamping force prediction for automatic drilling of stacked thin-walled workpieces based on finite element method

Dynamic Cutting Force Modeling and Experimental Study of Industrial Robotic Boring

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Suppressing the burr of high aspect ratio structure by optimizing the cutting parameters in the micro-milling process

Predictive Model for the Interlayer Burr Height During Drilling of Stacked Aluminum Plates

Mechanism of Burr Formation and Control Methods in Slot Milling Al-alloy

Mechanism Of Burr Formation In Slot Milling Al-Alloy

An Analytical Model to Predict Interfacial Burr Height for Metal Stack Drilling

Development of an enhanced burr accumulation model during orthogonal cutting of nickel-based super alloy

Researches on Burr Formation in Milling Al-Alloy

On the Steady-State Workpiece Flow Mechanism and Force Prediction Considering Piled-Up Effect and Dead Metal Zone Formation

Finite Element Modeling on Dislocation Density and Grain Size Evolution in Machined Surface

Burr formation mechanism and experimental research in longitudinal-torsional ultrasonic-assisted milling Ti-6Al-4 V

Experimental Investigation of the Influence of Chip Interference on Burr Height in Machining Micro V-grooves on Electroplated Copper Roll Die

Multi-physics analytical modeling of the primary shear zone and milling force prediction

Modeling and Optimization of Bidirectional Clamping Forces in Drilling of Stacked Aluminum Alloy Plates

Analytical modeling of milling residual stress under different tool wear conditions

Dislocation Density and Grain Size Evolution in the Machining of Al6061-T6 Alloys

A Finite Element Model for Micro Machining Considering Size Effect of Material Behaviour and Tool Geometry