Abstract:Introduction. Functionally graded materials are of great use, because heterogeneity of properties enables to control the strength and rigidity of structures. This has caused great interest in the topic in the world scientific literature. The construction of solutions to such problems depends significantly on the type of boundary conditions. In this paper, we consider the equilibrium of a thin-walled circular cylinder whose mechanical properties change along the radius. Homogeneous boundary conditions were set on cylindrical surfaces that had not been considered before, the effect was on the ends. The mathematical formulation of the problem was carried out in the linear theory of elasticity in the framework of axisymmetric deformation. Expressions were constructed for the components of the stress-strain state of the cylinder, in which some coefficients were found from the solution to the resulting system of linear algebraic equations. Materials and Methods. The material of the cylinder was linearly elastic, the elastic modulus of which depended linearly on the radial coordinate. The basic research method was the asymptotic method, in which half the logarithm of the ratio of the outer and inner radii acted as a small parameter. Iterative processes were used to construct the characteristics of the stress-strain state of the cylinder. Results. Homogeneous solutions to the boundary value problem were obtained for a linearly elastic functionally gradient hollow thin-walled cylinder. An analysis of these solutions made it possible to reveal the nature of the stress-strain state in the cylinder wall. For this purpose, an asymptotic analysis of the solutions was carried out, relations for displacements and stresses were obtained. It was determined that those solutions corresponded to the boundary layer, while their first terms determined Saint-Venant edge effect similar to the plate theory. Discussion and Conclusion. The analytical solution to the equilibrium problem of a thin-walled cylinder inhomogeneous in radius constructed by asymptotic expansion can be used for numerical solution to a specific problem. For this, it is required to solve the obtained systems of linear algebraic equations and determine the corresponding coefficients. The resulting asymptotic representations provide analyzing the three-dimensional stress-strain state. The selection of the number of expansion terms makes it possible to calculate displacements and stresses with a given degree of accuracy. This analysis can be useful in assessing the adequacy of applied calculation methods used in engineering practice.

Variable properties reconstruction for functionally graded thermoelectroelastic cylinder

Low Dimensional Nonlinear Thermomechanical Models Describing Phase Transformations And Their Applications

Low Dimensional Approximations to Ferroelastic Dynamics and Hysteretic Behavior Due to Phase Transformations

Simulation of nonlinear thermomechanical waves with an empirical low dimensional model

The Transient Responses of a Special Non-Homogeneous Magneto-Electro-elastic Hollow Cylinder for Axisymmetric Plane Strain Problem

TRANSIENT THERMOELASTIC SOLUTION OF A MULTILAYERED ORTHOTROPIC HOLLOW CYLINDER FOR AXISYMMETRIC PROBLEMS

Transient responses of a special non-homogeneous magneto-electro-elastic hollow cylinder for a fully coupled axisymmetric plane strain problem

Novel Semi-Analytical Solutions For The Transient Behaviors Of Functionally Graded Material Plates In The Thermal Environment

Transient Responses of a Magneto-Electro-elastic Hollow Sphere for Fully Coupled Spherically Symmetric Problem

Exact Solution and Transient Behavior for Torsional Vibration of Functionally Graded Finite Hollow Cylinders

Axisymmetric bending of functionally graded circular magneto-electro- elastic plates

Thermoelastic State of a Piecewise Inhomogeneous Orthotropic Thermosensitive Cylinder

Non-axisymmetric non-stationary problem of thermoelectroelasticity for a long piezo-ceramic cylinder

Unsteady temperature distribution in a cylinder made of functionally graded materials under circumferentially-varying convective heat transfer boundary conditions

Analysis of Stress-Strain State of a Cylinder with Variable Elasticity Moduli Based on Three-Dimensional Equations of Elasticity Theory

The Calculation of Double Nonlinearity and Material Anisotropy Influence on the Temperature Distribution in the Cylinder Under High Temperature Heat Exchange

Non-Axisymmetric Coupled Unsteady Thermoelectroelasticity Problem for a Long Piezoceramic Cylinder

Investigation on the electro-magneto-thermoviscoelastic response of multilayer rotating hollow cylinder based on two-temperature theory and fractional-order viscoelastic systems

A Theoretical Solution of Cylindrically Isotropic Cylindrical Tube for Axisymmetric Plane Strain Dynamic Thermoelastic Problem

Exact Transient Heat Conduction of Functionally Graded Thick Structures

A Solution of a Non-Homogeneous Orthotropic Cylindrical Shell for Axisymmetric Plane Strain Dynamic Thermoelastic Problems