Abstract:A greater understanding of protein functionality and its impact on processing and end-product quality is critical for the success of the fast-growing market for plant-based meat products. In this research, simple criteria were developed for categorizing plant proteins derived from soy, yellow pea, and wheat as cold swelling (CS) or heat swelling (HS) through various raw-material tests, including the water absorption index (WAI), least gelation concentration (LGC), rapid visco analysis (RVA), and % protein solubility. These proteins were blended together in different cold-swelling: heat-swelling ratios (0:100 to 90:10 or 0–90% CS) and extruded to obtain texturized vegetable proteins (TVPs). In general, the WAI (2.51–5.61 g/g) and protein solubility (20–46%) showed an increasing trend, while the LGC decreased from 17–18% to 14–15% with an increase in the % CS in raw protein blends. Blends with high CS (60–90%) showed a clear RVA cold viscosity peak, while low-CS (0–40%) blends exhibited minimal swelling. The extrusion-specific mechanical energy for low-CS blends (average 930 kJ/kg) and high-CS blends (average 949 kJ/kg) was similar, even though both were processed with similar in-barrel moisture, but the former had substantially lower protein content (69.7 versus 76.6%). Extrusion led to the aggregation of proteins in all treatments, as seen from the SDS-PAGE and SEC-HPLC analyses, but the protein solubility decreased the most for the high-CS (60–90%) blends as compared to the low-CS (0–40%) blends. This indicated a higher degree of crosslinking due to extrusion for high CS, which, in turn, resulted in a lower extruded TVP bulk density and higher water-holding capacity (average 187 g/L and 4.2 g/g, respectively) as compared to the low-CS treatments (average 226 g/L and 2.9 g/g, respectively). These trends matched with the densely layered microstructure of TVP with low CS and an increase in pores and a spongier structure for high CS, as observed using optical microscopy. The microstructure, bulk density, and WHC observations corresponded well with texture-profile-analysis (TPA) hardness of TVP patties, which decreased from 6949 to 3649 g with an increase in CS from 0 to 90%. The consumer test overall-liking scores (9-point hedonic scale) for TVP patties were significantly lower (3.8–5.1) as compared to beef hamburgers (7.6) (p < 0.05). The data indicated that an improvement in both the texture and flavor of the former might result in a better sensory profile and greater acceptance.

Comparative Evaluation of Polysaccharide Binders on the Quality Characteristics of Plant-Based Patties

Effect of Different Polysaccharides on the Texture and Fibrous Structure of High-Moisture Extruded Pea Protein Isolate

Evaluating the sensory properties of hybrid (meat and plant‐based) burger patties

Quality Characteristics of Substitute Meat Patties Developed Using Aruncus dioicus var. kamtschaticus Hara

Effect of Transglutaminase-Catalyzed Crosslinking Behavior on the Quality Characteristics of Plant-Based Burger Patties: A Comparative Study with Methylcellulose.

Pea protein–sugar beet pectin binders can provide cohesiveness in burger type meat analogues

Quality, Thermo-Rheology, and Microstructure Characteristics of Cubic Fat Substituted Pork Patties with Composite Emulsion Gel Composed of Konjac Glucomannan and Soy Protein Isolate

Structural properties of meat analogue with added konjac gels

Characterization of plant-based meat alternatives blended with anthocyanins, chlorophyll, and various edible natural pigments

Understanding Protein Functionality and Its Impact on Quality of Plant-Based Meat Analogues

Comparison of Physico-Chemical and Sensory Attributes in Plant-Based Meat Analogue Patties and Chicken Patties

Investigation into the fabrication of plant-based simulant connective tissue utilizing algae polysaccharide-derived hydrogel

Impact of konjac glucomannan with varied deacetylation degrees on plant-based meat analogue: Study on the gel properties, digestibility, and microstructure

Quality characteristics and volatile compounds of plant-based patties supplemented with biji powder

Mimic Pork Rinds from Plant-Based Gel: The Influence of Sweet Potato Starch and Konjac Glucomannan

Characteristics of Beef Patties Substituted by Different Levels of Textured Vegetable Protein and Taste Traits Assessed by Electronic Tongue System

Texture improvement and in vitro digestion modulation of plant-based fish cake analogue by incorporating hydrocolloid blends

Enhancing emulsion, texture, rheological and sensory properties of plant-based meat analogs with green tea extracts

Meat and Plant-Based Meat Analogs: Nutritional Profile and in Vitro Digestion Comparison

Evaluation of the Physicochemical and Structural Properties and the Sensory Characteristics of Meat Analogues Prepared with Various Non-Animal Based Liquid Additives

Advancing plant-based meat analogs: Composite blend of pulse protein reinforcing structure with fibrous mushroom, jackfruit seed powder and carboxymethyl cellulose