Abstract:Increasing demands for cost-effective electric vehicles and electrochemical energy storage systems require advanced secondary batteries with higher energy density, longer lifetime, and enhanced safety. Increase of the battery operating voltage is one realistic strategy to extend the energy density, but it is accompanied by irreversible structural changes to the electrodes and parasitic reactions within an electrode-electrolyte interphase resulting in capacity fading and subsequent battery failure. Therefore, a fundamental understanding of underlying electrochemical mechanisms in the electrodes during battery cycling is critical for the development of next-generation secondary batteries. Based on our previous studies utilizing in situ surface-enhanced Raman spectroscopy to monitor the evolution of the Si-electrolyte interphase 1 and in situ ATR-FTIR to investigate the voltage dependent electrolyte solution structure changes at the interface, transition metal redox chemistry, and cathode/electrolyte interfacial layer evolution, 2 recently we updated the in situATR-FTIR with a newly designed 'full-cell' that enables us to analyze the interfacial reactions and interactions on the surfaces of both electrodes that directly influence battery performance, lifetime, and safety. Specifically, we focus on transition metal complex formation and its effect on solid-electrolyte interphase (SEI) formation and evolution on the anode due to transition metal dissolution and crosstalk of Mn-rich cathodes at high voltages (≥4.4 V). In addition, using our multi-modal characterization—a combination of in situ gas chromatography with flame ionization detection (GC-FID) and in situ ATR-FTIR—(electro)chemical degradation of the electrolyte is correlated with gas evolution in the battery. For example, GC-FID measures increasing amounts of ethylene gas until the end the first charging cycle of a LiNiO 2 //Graphite cell with Gen2 electrolyte (LiPF 6 in ethylene carbonate (EC):ethyl methyl carbonate (EMC), 3:7 wt.%). Concurrently, in situ ATR-FTIR shows decreasing concentration of EC solvent, as calculated from the FTIR intensity of EC vibrational absorption. Ethylene is a known by-product of ethylene carbonate electrochemical reduction and is produced during SEI formation. 3 Quantifying multiphase reactions occurring during battery operation is critical to understanding and mitigating battery degradation pathways, and developing next-generation battery materials systems. References: Ha, B. J. Tremolet de Villers, Z. Li, Y. Xu, P. Stradins, A. Zakutayev, A. Burrell and S.-D. Han, "Probing the Evolution of Surface Chemistry at the Silicon-Electrolyte Interphase via In-situ Surface-Enhanced Raman Spectroscopy," J. Phys. Chem. Lett. 2020, 11, 286-291. J. Tremolet de Villers, J. Yang, S.-M. Bak and S.-D. Han, "In Situ ATR-FTIR Study of Cathode-Electrolyte Interphase: Electrolyte Solution Structure, Transition Metal Redox, and Surface Layer Evolution," Batter. Supercaps 2021, 4, 778-784. Han, C. Liao, F. Dogan, S. E. Trask, S. H. Lapidus, J. T. Vaughey and B. Key, "Using Mixed Salt Electrolytes to Stabilize Silicon Anodes for Lithium-Ion Batteries via in Situ Formation of Li–M–Si Ternaries (M = Mg, Zn, Al, Ca)," ACS Appl. Mater. Interfaces 2019, 11, 29780-29790.

Using Machine Learning and Infrared Spectroscopy to Quantify Species Concentrations in Battery Electrolytes

Chemometric and Machine Learning Analysis of Lithium Concentration and Solvation Behavior in Li-Ion Battery Electrolytes

Time-frequency Analysis of the Spatial Distribution for Li+concentration in the Electrolyte Throughout the Full Battery

Artificial intelligence for the understanding of electrolyte chemistry and electrode interface in lithium battery

Transfer Learning Enabled Deep Learning Model for the Prediction of Battery Performance from Electrolyte Formulations

Machine Learning Based Identification of Lithium-Ion Battery Cell Chemistries

Confluence of Electronic Structure Calculations (DFT) and Machine Learning (ML) for Lithium and Sodium-Ion Batteries: ATheoretical Perspective

Detecting lithium plating dynamics in a solid-state battery with operando X-ray computed tomography using machine learning

Nanoscale Imaging of Lithium Ion Distribution During In Situ Operation of Battery Electrode and Electrolyte

Hollow-core optical fibre sensors for operando Raman spectroscopy investigation of Li-ion battery liquid electrolytes

Autonomous discovery of battery electrolytes with robotic experimentation and machine-learning

Hyphenated DEMS and ATR-SEIRAS techniques for <i>in situ</i> multidimensional analysis of lithium-ion batteries and beyond

Machine learning 3D-resolved prediction of electrolyte infiltration in battery porous electrodes

Hyphenated DEMS and ATR-SEIRAS techniques for in situ multidimensional analysis of lithium-ion batteries and beyond

Electrolytomics: A unified big data approach for electrolyte design and discovery

Non-aqueous battery electrolytes: high-throughput experimentation and machine learning-aided optimization of ionic conductivity

Quantification of Lithium Plating in Lithium-Ion Batteries Based on Impedance Spectrum and Artificial Neural Network

Machine Learning Screening of Metal-Ion Battery Electrode Materials

Integrated Supervised and Unsupervised Machine Learning Approach to Map the Electrochemical Windows Over 4500 Solvents for Battery Applications

Design and Optimization of Multicomponent Electrolytes for Lithium‐Sulfur Battery: A Machine Learning Concept and Outlook

In Situ Multi-Modal Approach for Electrode-Electrolyte Interfacial Chemistryand Electrode and Electrolyte Aging Behavior Studies