Abstract:Many previous studies have examined solid-state particle discharge systems. However, several drawbacks have been encountered in terms of laboratory-scale particle feeding systems (e.g., high feeding rates, discontinuous feeding characteristics, the absence of long-term stability, and the use of high carrier gas volume rates). In this study, a state-of-the-art screw-assisted rotary feeding system was developed and evaluated in terms of aerosolization characteristics such as particle number concentration, geometric mean diameter, and geometric standard deviation. The various experimental conditions included changes in the rotational speed of the rotor, changes in the number of rotor grooves, and the existence or nonexistence of screw operation. Calcium carbonate (CaCO 3 ) powder was selected as the discharged sorbent particle. To verify the performance of the designed feeding system, we measured number concentrations with and without operation of the screw. Uniformity (i.e., the steadiness of feeding characteristics over time) was analyzed using a condensation particle counter. As the rotational speed and the number of rotor grooves increased, the number concentration and the frequency of discharging sorbent particles increased, whereas the coefficient of variation decreased. However, when the loading time was less than the critical time (∼0.8 s), the number concentration decreased and the coefficient of variation increased again according to the rotational speed. Stability (i.e., the invariability of the size distribution in various rotational speeds of the rotor for three different rotors) was also analyzed using an aerodynamic particle sizer and a scanning mobility particle sizer. The results of both aerosol measurement and scanning electron microscopy analysis showed that the geometric mean diameter and the geometric standard deviation of aerosolized sorbent particles remained constant under all the experimental conditions. We also determined that the region in which the coefficient of variation was less than 0.1 was the stable operation region for this screw-assisted rotary feeding system.

Stability optimization of periodic mass flow rate fluctuation in the variable diameter extension screw

Finite Element Analysis and Optimal Researchon Plasticizing Capacity of Screws

Design and Simulation of a Hydraulic System for Jumbo Screw Conveyors Based on Flow Compensation

DEM Investigation on Conveying of Non-Spherical Particles in a Screw Conveyor

Flow characteristics of particles in water-cooled screw conveyor

Experimental Research on a Micro-particle and Micro-quantity Screw Feeder

Research on Hollow Screw Microfeeding Device

Study of the grain particle-conveying performance of a bionic non-smooth-structure screw conveyor

Analysis of the flow of granular materials through a screw conveyor

Structure Optimization Design of Screw Conveyor based on EDEM

Improvements on a Gravity-Driven Low-Rate Particle Feeder

Investigation of the Vibrating Feeding System for Sphericity Separation of Coated Fuel Particles Using DEM

A comparative study on design standards of screw conveyors in China, Germany, and the USA – Part II: Discrete element method

Numerical Study on Particle Mixing in a Double-Screw Conical Mixer

Using vibration to attenuate the adhesive friction behavior between screw conveyor blades and wet coal particles

The influence of faceted particle shapes on material dynamics in screw conveying

Analysis Of Fluidizing Stability In Dense Prase Powder Feeder

Comparison of computational fluid dynamics–discrete element method and discrete element method simulations for a screw conveyor

Design and Characterization of an Improved Screw-Assisted Rotary Feeding System for Aerosolization of Ultra-Small Quantities of Particulate Solids

Investigating screw-agitator speed ratio impact on feeding performance in pharmaceutical manufacturing using discrete element method

Simulation and Analysis of Milling Formula Screw Based on EDEM