Abstract:Background: An alveolar ridge preservation (ARP) procedure is commonly performed to preserve ridge width and height for optimal dental implant placement. Mixing different sources of bone grafts may help maximize their properties to obtain predictable ARP results. Objective: The aim of this case series is to highlight the clinical and radiographic outcomes of a combined allograft and xenograft approach for a predictable ARP procedure. Materials and methods: Eleven clinical cases that required tooth extraction and future implant placement were selected for this case series. All surgeries were performed by a single clinician in a private practice setting. All cases underwent an ARP procedure, which included atraumatic extraction, degranulation, assessment of the socket, and the use of a combination of allograft and xenograft fibers/granules in a 1:1 mixing approach. Based on the socket defect, either a type I or type III collagen membrane was used during the procedure. In all cases CBCT imaging was done prior to surgical implant placement, and digital implant planning was performed integrating interdisciplinary best practices. Implant placement was carried out using manufacturer's recommendations. Results: Five male and five female patients were included in the study, with one of the male patients having two teeth extracted for a total of 11 cases. The reasons for teeth extraction included fracture, endodontic failure, periodontal infection, and subgingival decay. Healing was uneventful after the ARP procedure for all patients. A minimum of 120 days elapsed between ARP and the surgical implant procedure. Complete radiographic bone fill was observed in the CBCT image for all extraction sites, and no additional bone augmentation was needed at the time of implant placement. Conclusion: This case series demonstrates that based on clinical and radiographic outcomes, a combination of allogenic and xenogenic bone substitute can be utilized to obtain predictable results following ARP. Future randomized controlled trials that can compare different ratios between the two biomaterials are indicated to guide clinicians in the mixing protocols and their outcomes.

METHOD OF TRANSPLANTATION OF A COMBINED OSTEOPERIOSSTEAL GRAFT TO INCREASE THE VOLUME OF THE ALVEOLAR RIDGE BEFORE DENTAL IMPLANTATION (CLINICAL CASE)

ORTHODONTIC EXTRUSION TECHNIQUE AS A METHOD FOR ALVEOLAR BONE VOLUME INCREASE BEFORE DENTAL IMPLANTATION. CLINICAL CASE

Application of autogenous dentinal block to increase alveolar bone volume: a clinical case

A three-in-one alveolar process reconstruction protocol for maxillary molar sites with severe residual bone height deficiency: A proof-of-concept pilot study

Combined application of artificial bone powders and concentrated growth factor membranes on the autotransplantation of mature third molars: A 5‐year retrospective case series

Comparative Effectiveness of an Autologous Dentin Matrix for Alveolar Ridge Preservation

Immediate single-tooth replacement with acellular dermal matrix allogeneic bone and ossifying collagen scaffold: A case series

Tooth Autotransplantation, Autogenous Dentin Graft, and Growth Factors Application: A Method for Preserving the Alveolar Ridge in Cases of Severe Infraocclusion-A Case Report and Literature Review

[Dental implantation and soft tissue augmentation after ridge preservation in a molar site: a case report]

Three-dimensional analysis of bone remodeling following ridge augmentation of compromised extraction sockets in periodontitis patients: A randomized controlled study

Alveolar Bone Reconstruction Simultaneous to Implant Removal due to Advanced Peri‐Implantitis Defects: A Proof of Concept

Combined use of PRPP, diode laser and piezosurgery device improves reparative osteogenesis previously to dental implants placement

Bilamina Cortical Tenting Grafting Technique for Three-Dimensional Reconstruction of Severely Atrophic Alveolar Ridges in Anterior Maxillae: A 6-Year Prospective Study.

Modified 3-Dimensional Alveolar Ridge Augmentation in the Anterior Maxilla: A Prospective Clinical Feasibility Study

Prefabricated CAD‐CAM scaffolds for management of oro‐antral communication: A case report and histological analysis

Mixing Allograft and Xenograft for a Predictable Alveolar Ridge Preservation Procedure: A Case Series

A New Modified Bone Grafting Technique for Periodontally Accelerated Osteogenic Orthodontics

A modified crestal ridge expansion technique for immediate placement of implants: a report of three cases

Autogenous bone ring augmentation around single tooth implantation in the esthetic zone: A retrospective case series study with 2–3 years of follow-up

Three-dimensional bone grafting in dental implantology using autogenous bone ring transplant: Clinical outcomes of a one-stage technique

Histological justification of the application of materials based on biomodified hyaluronic acid in combination with xenogenic osteoplastic material for maxillary alveolar bone augmentation before dental implantation