Fabrication of an antibacterial zinc oxide film on biodegradable magnesium alloy and its biocompatibility

Jie Yuan,Bo Sheng,Geng Tang,Qibin Liu

DOI: https://doi.org/10.1007/s12206-023-0754-5

IF: 1.81

2023-08-01

Journal of Mechanical Science and Technology

Abstract:To avoid the rapid degradation of magnesium alloy AZ31B after implantation in the body, the addition of a zinc oxide (ZnO) film was examined. A rough surface was fabricated by femtosecond laser on AZ31B at frequencies of 100, 200, 300, 500, and 800 kHz, before adding a ZnO film by wet metallurgy. Scanning electron microscopy (SEM) indicated that 500 kHz femtosecond laser frequency produced a coral-like surface morphology on AZ31B and the ZnO film had a needle-like structure. X-ray diffraction (XRD) revealed that the film mainly consisted of Zn and ZnO. Potentiodynamic polarization curves revealed that the ZnO film exhibited a better corrosion resistance than bare AZ31B. It also possessed superior cell proliferation ability and higher suppression of a representative device-related infection of Escherichia coli strain than bare AZ31B. This study provides a novel film strategy for manufacturing biodegradable magnesium alloys with good corrosion resistance, biocompatibility, and antibacterial properties.

engineering, mechanical